Hotpoint 14 - Drawer & Cover Removal

Plastic Drawer and Cover Removal (on
Pull the drawers straight out.
To remove the cover, lift it off its supports,
pull it forward, tilt it and take it out.
(continual)
some models)
Wn Drawer With Glass Cover (on some models)
To remove the glass cover:
1.
Remove the drawers.
2. Reach in, push the front of ,
0
.1
glass cover up and, at the
same time, pull it forward as .-
—— -
.- ~öˆ=è•£=¹Û›=€••?T¹H•d•Ÿ=€
far as it will come.
Ileli
+
,,
—
..J.
4
Tilt it and take it out. Avoid
cleaning the cold glass cover
with hot water because the
extreme
temperamre difference
may cause it to break.
H
‘,
., —-
‘%
+:*
+“
.—
~~
3. Remove the drawer frame. (Always remove the
glass cover before you take out the drawer frame.)
Lift the frame off the supports at each side and back,
pull it forward, tilt it and take it out.
To repIace the glass cover:
1.
Lower the frame until it rests on the supports at
each side and back.
2. Replace the glass cover, pushing its rear edge
fihy into the rear frame channel and gently
lowering the front into place.
3. Replace the drawers.
Light Bdb Replacement
A light bulb and socket are located at the top of the fresh food compartment >
just behind the temperature control panel. To replace the bulb, unplug the
refrigerator from its electrical outlet, unscrew the bulb when cool, and
=
replace with same size bulb.
Q
*= ❑ ~, <
--= = =- --
——
-- - -.
1 I :’1’
—
Behind Refrigerator
Be careful moving your refrigerator away from the
wall. All types of floor coverings can be damaged,
particularly cushioned coverings and those with
embossed surfaces.
Turn the leveling legs at each front comer of the
refrigerator counter-clockwise until the rollers support
the refrigerator; then pull the refrigerator straight out
and return it to position by pushing it straight in.
Moving your refrigerator in a side
dirwtion may result
in damage to your floor covering or refrigerator.
When pushing the refrigerator back, make sure you
don’t roll over the power cord or
icemaker supply line
(on some models).
—
After rolling the refrigerator back into place, turn the
legs clockwise until the legs again bear the weight of
the refrigerator.