Enable it with the key.
The display shows:
and press the key to confirm.
! The “RESET” must be given whenever a new
cartridge filter is installed.
For this command, use the
key to select the
function:
Enable it with the key.
TEMPERATURE
This function regulates the temperature of the water
for coffee (high, medium and low).
Use the key to select the function
TEMPERATURE *
PROGR. COFFEE LENG.
Enable it with the key.
The display shows (e.g.):
Select the required temperature by pressing the
key and use the key to save your choice.
PROGRAMMING COFFEE SIZE
This function enables you to regulate the amount of
coffee brewed when the ( , or ) keys are
pressed.
You can program the amount dispensed one key at
a time Continue repeating the procedure described
below to program several keys.
Use the key to select the function
PROGR. COFFEE LENG.*
PROGR. WATER AMOUNT
Enable it with the key.
The display shows:
SELECT PRODUCT
PROGRAMM. COFFEE
! In this phase, if the display remains idle for a certain
amount of time, the machine exits the function.
Position the cup that you want to fill.
Press the key to brew the required type of coffee ( ,
or ); this is shown on the display (e.g.):
1 SMALL COFFEE
PROGRAMM. COFFEE
Wait for the cup to fill with the required amount. Press
the key again.
PROGRAMMING THE QUANTITY OF WATER
This function enables you to regulate the amount of
water that is dispensed whenever is pressed. You
need just one key to fill your container with the right
amount of water
Use the key to select the function
PROGR. WATER AMOUNT*
PROGRAM STEAM TIME
To Next Page
Loading...