Hotpoint HHP7.5CM - Maintenance and Care

GB
11
PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24
Maintenance and care
Caution! Before cleaning or servicing the unit,
disconnect it from the mains by pulling the power plug
or disconnecting the main circuit breaker.
First cleaning
• Removetheprotectivelm
• Cleanwithadampspongeandalittleneutralsoap
• Rinseoffwithadampcloth
• Drywithasoftcloth;ifthehoodisstainlesssteel,dry
alongthemetal'sgrain
Periodic cleaning
The hood must be cleaned frequently (at least as often as
youservicethegreaselter),insideandout.Useadamp
cloth and a neutral liquid detergent with lukewarm water.
Do not use abrasive or corrosive products.
Warning:Failuretoobservethehoodcleaningandlter
cleaning/replacementinstructionscanresultinres.Follow
the instructions carefully. The manufacturer is not liable for
anydamagetothemotororrescausedbyincorrectcare
or failure to follow the above instructions.
Servicing the grease lter (A)
A
The grease lter retains the
particles of grease produced
during cooking; it must be
cleaned at least once a month
with a non-aggressive
detergent, either by hand or
with a low temperature, short
dishwasher cycle.
To extract the grease lter,
pull the spring loaded handle.
If washed in a dishwasher, the metal lter may change
colour, but this does not affect its performance.
Servicing the charcoal lter (B)
B
The charcoal filter retains
unpleasant cooking odours.
The filter saturates after a
variable time, depending on
the type of cooking and how
often the grease filter is
cleaned. The cartridge must
be replaced at least once
every twenty months.
ThisltercanNOTbewashed
or regenerated
Disassembly:Rotatethelter90°toremoveitfromthe
suction assembly.
Assembly: Fit the active-carbon lter into the suction
assembly and rotate it 90° to secure it in place.
Replacing the bulbs
Disconnect the unit from the mains and remove the grease
lter.
Caution! Make sure the bulbs are cool before touching
them.
1.Extracttheguard
by prising it out with a small
flat head screwdriver or
something similar.
2. Replace the faulty bulb.
Use only bulbs of the
same type (for details,
see the technical data in
the following manual).
3.Rettheguard(pushitin).
Replacing the lights LED
*
The hood is tted with a lighting system based on LED
technology.TheLEDsensureoptimallighting,longerlife
and lower consumption compared with traditional lights. To
replace them please contact the assistance service.
Electrical cable
If the power cable is damaged, it can be replaced by the
manufacturer or his technical service, to prevent any
attendant risks.
SCRAPPING
TheunitismarkedforconformitywithEuropeanDirective
2012/19/EC, Waste Electrical and Electronic Equipment
(WEEE). By ensuring that the unit is scrapped properly,
the user contributes to safeguarding the environment and
public health.
The
symbol on the product or on its accompanying
documents indicates that the product may not be treated
as domestic waste but must be handed over to a sorting
centre for electrical and electronic waste. Dispose of it
in accordance with local waste disposal regulations. For
further information on the handling, recovery and recycling
of this product, contact the local authority, domestic waste
disposal service or the reseller from whom you purchased it
*
Only available in certain models
GB