Caring for your Cooker Hood
10
Cleaning:
The exterior of the Cooker Hood should be
cleaned regularly to keep it looking like new.
Wipe over with a soft cloth, wrung out in
warm water and dry with a clean soft cloth.
Wear protective gloves.
You can use mild non-abrasive cleaners but
always read the manufacturer’s instructions
first. Always test their suitability on a small
area of the Cooker Hood not noticeable in
normal use.
NOTE: DO NOT use scouring pads or
abrasive cleaners as they may scratch the
surface.
How to replace the light:
Should the light fail to work, switch ‘Off’the
mains supply to the Hood.
Open the grille and check the bulb is screwed
securely into the bulb holder then switch ‘On’
the mains supply.
If the light fails to work do not worry, it will
not affect the working of your hood. Obtain a
replacement 40 watt (E14) bulb. Switch ‘Off’
the mains supply. Unscrew the old bulb anti-
clockwise to remove and replace with the
new bulb turning clockwise until secure. Refit
the filter grille and switch back ‘On’at the
mains.
NOTE: When changing the bulb, an
identical replacement must be fitted to
ensure the safe operation of the hood.
Fig.14
To Next Page
Loading...
