EN
5
Anti-condensation strip*
After installing the dishwasher, open the door and stick the
adhesive transparent strip under the wooden shelf in order
to protect it from any condensation which may form.
Advice regarding the first wash cycle
After the installation, remove the stoppers from the racks and the
retaining elastic elements from the upper rack, if any.
Immediately before the first washing, completely fill the salt
dispenserwithwaterandaddonlythenapproximately1kgofsalt
(seechapterentitledRinseaidandrefinedsalt).Thewatermay
overflow: this is normal and is not a cause for concern. Select
thewaterhardnessvalue(seechapterentitledRinseaidand
refined salt). - After the salt has been poured into the machine,
theLOWSALTindicatorlight*switchesoff.
If the salt container is not filled, the water softener and
the heating element may be damaged as a result.
Technical data
Dimensions
Capacity
Water supply
pressure
Power supply
voltage
Total absorbed
power
Fuse
The machine has a buzzer/set of tones
(depending on the
dishwasher model
) to inform the user that a command has
been implemented: power on, cycle end etc.
The symbols/indicator lights/LEDs on the control panel/
display may vary in colour and may have a flashing or fixed
light
(depending on the dishwasher model)
.
The display provides useful information concerning the type
of wash cycle, drying/wash-cycle phase, remaining time,
temperature etc etc.
* Only available in selected models.
Before contacting Assistance:
• Checkwhethertheproblemcanberesolvedusingthe
Troubleshooting guide
(see Troubleshooting).
• Restarttheprogrammetocheckwhethertheproblem
has ceased to exist.
• If the problem persists, contact the Authorised
Technical Assistance Service.
Never use the services of unauthorised technicians.
Please have the following information to hand:
• Thetypeofmalfunction.
• Theappliancemodel(Mod.).
• Theserialnumber(S/N).
This information can be found on the appliance data plate
(see Description of the appliance)
.
Assistance
To Next Page
Loading...
