To Next PageTo Next Page
Need help?Do you have a question about the Hotpoint LTF11M121OUK and is the answer not in the manual?
General| Type | Freestanding |
|---|---|
| Appliance placement | Freestanding |
| Built-in display | Yes |
| Tub material | Stainless steel |
| Inlet hose length | 1.55 m |
| Outlet hose length | 1.5 m |
| Noise level | 41 dB |
| Number of washing programs | 11 |
| Delayed start timer | Yes |
| Delayed start | Up to 24 hours |
| AquaStop function | Yes |
| Adjustable feet | Yes |
| Water consumption per cycle | 9.5 L |
| Power consumption (off) | 0.5 W |
| Connected load | 1900 W |
| AC input voltage | 220-240 V |
| AC input frequency | 50 Hz |
| Drying Performance | A |
| Cleaning Performance | A |
| Half Load Option | Yes |
| Colour | White |
| Product size | 60 cm |
| Number of place settings | 14 place settings |
| Washing programs | Eco, Intensive, Normal |
| Energy efficiency class | A |
| Energy consumption per cycle | 0.73 kWh |
| Width | 60 cm |
| Depth | 590 mm |
| Height | 85 cm |
| Annual Energy Consumption | 266 kWh |
Details the Zone Wash function for selective rack cleaning.
Explains the Extra Dry function to improve drying performance.
Describes the Active Oxygen feature for hygiene and odor control.
Explains how wash/drain pumps act as virtual sensors for water level detection.
Describes the BLAC motor drain pump and its function.
Step-by-step process of water filling using virtual sensors.
Discusses common errors related to filling and draining.
Details the operation of the combined dispenser unit.
Explains the ozone function for hygiene and odor control.
Describes the rinse aid warning light and dispenser settings.
Details the BLAC wash pump motor, its features, and sensor function.
Explains the motor that directs water to spray arms.
Describes the heating element and its temperature sensing component.
Details the low salt warning indicator and its function.
Explains the natural drying method using residual heat and rinse aid.
Procedure for removing the base access panel.
Steps to remove the main wash motor and heater assembly.
Steps to remove the drain pump from the sump.
Procedure for accessing and disconnecting the pressure switch.
Procedure for removing the water softener unit.
Steps to detach and remove the sump assembly.
Steps to remove the display board from the inner door.
Detailed instructions for replacing the door hinges.
Explains causes and solutions for white coating or scale inside the machine.
Addresses issues causing cloudy film on glassware.
Factors affecting drying efficiency and how to improve it.
Explains potential causes of chipping on dishes.
Causes and prevention of tarnishing or discoloration on cutlery.
Discusses staining of internal plastic parts.
