To Next PageTo Next PageWhy are my dishes streaked or have a bluish tinge after using my Hotpoint Dishwasher?
If your dishes are streaked or have a bluish tinge after being washed in your Hotpoint dishwasher, it's likely that the rinse aid dosage is too high.
Why is my Hotpoint LTB 4B019 crockery not clean?
If your crockery isn't coming out clean from your Hotpoint dishwasher, several factors could be at play. Make sure that you are not overloading the racks and that the crockery is arranged properly, allowing the sprayer arms to move freely. Check that you've selected an appropriate wash cycle. Ensure that you're using the correct amount of detergent and that the lid on the rinse aid compartment is correctly shut. Also, verify that the filter isn't dirty or blocked and that the refined salt level is adequate. If problems persist, switch off the appliance, turn off the water tap, unplug the appliance and make sure the water inlet filter has not become blocked by impurities.
What to do if no water drains from my Hotpoint Dishwasher?
If water isn't draining from your Hotpoint dishwasher, consider these possibilities: the dishwasher cycle may not have finished yet. Check the water drain hose to ensure it isn't bent. Make sure the drain duct isn't blocked, and inspect the filter for any food residues that may be clogging it.
What to do if my Hotpoint LTB 4B019 Dishwasher does not take any water in?
If your Hotpoint dishwasher isn't taking in water, it could be due to several reasons. Check that there is water in the mains supply and that the water inlet hose isn't bent. Try turning on the tap; the appliance should start after a few minutes. If the appliance lock has been activated because no action was taken when the beeps sounded, switch off the machine using the ON/OFF button, turn on the tap, and switch the machine back on after a few seconds. Then, re-program the appliance and restart the wash cycle.
Why is crockery not drying properly in my Hotpoint LTB 4B019 Dishwasher?
If your crockery isn't drying properly in your Hotpoint dishwasher, it could be because you've selected a wash cycle without a drying cycle. Also, check if the rinse aid has been used up or if the dosage is too low, or if the rinse aid setting is not suitable. Note that crockery made from non-stick material or plastic may not dry as effectively.
Why is my Hotpoint LTB 4B019 making excessive noise?
If your Hotpoint dishwasher is making excessive noise, it could be due to the dishes rattling against each other or against the spray arms. Ensure that the dishes are placed properly and that the spray arms can rotate freely. Also, excessive foam from using too much detergent or unsuitable detergent can cause noise. Avoid pre-washing dishes by hand.
Why is my Hotpoint Dishwasher too noisy?
If your Hotpoint dishwasher is making excessive noise, check if the dishes are rattling against each other or against the sprayer arms. Another possible cause is an excessive amount of foam, which could be due to using too much detergent or a detergent that isn't suitable for dishwashers.
What to do if the door won’t close on my Hotpoint LTB 4B019?
If the door of your Hotpoint Dishwasher won’t close, it may be that the lock was released. Try pushing the door firmly until you hear a 'clacking' noise.
Why are there white film or limescale deposits on my Hotpoint LTB 4B019 dishes and glasses?
If you notice a white film or limescale deposits on your dishes and glasses after using your Hotpoint dishwasher, it could be due to a few reasons. The level of refined salt might be low, or the dosage setting might not be appropriate for the water hardness. Ensure that the lid on the salt dispenser is properly closed. Also, check if the rinse aid has been used up or if the dosage is too low.
What to do if my Hotpoint LTB 4B019 won't drain water?
If no water drains from your Hotpoint dishwasher, consider the following: * Ensure the wash cycle has completed. * Check the water drain hose for bends (see Installation). * Inspect the drain duct for clogs. * Clean the filter if it's clogged with food residues. * Verify the height of the drain hose.
General| Type | Freestanding |
|---|---|
| Number of Place Settings | 13 |
| Noise Level | 49 dB |
| Dimensions (H x W x D) | 85 x 60 x 60 cm |
| Control Panel Colour | Black |
| Number of Washing Programs | 4 |
| Drying System | Static |
| Delayed Start Timer | Yes |
| Child Lock | No |
| Washing Programs | Eco, Intensive, Normal |
| Cycle Time | 190 minutes |
| Delay Start (max) | 24 hours |
Important safety information for using the appliance safely, covering user responsibilities and prohibitions.
Instructions for correctly positioning and levelling the dishwasher on a stable floor for optimal operation.
Steps and precautions for connecting the water inlet hose to the water supply.
Guidance on connecting the drain hose to a drain duct, ensuring proper height and avoiding blockages.
Description of the appliance's special system and supplementary devices to prevent floods.
Guidance on correctly measuring detergent for optimal wash results and environmental protection.
Step-by-step instructions on how to start a wash cycle, including pre-checks and post-cycle actions.
Guidance on selecting wash cycles, understanding their data, and proper detergent dosage.
Procedures for safely turning off water and electricity before cleaning or maintenance.
Detailed guide on how to remove, clean, and reassemble the filter assembly for optimal performance.
Solutions for issues where the appliance fails to start or respond to controls.
Troubleshooting steps for when the dishwasher door does not latch securely.
Causes and solutions for the dishwasher not draining water after a cycle.
