Hotpoint RB536 - Glass Cooktop Care; Daily and Burned-On Residue Cleaning

Cleaningtheglass cooktop, ionsomemode sl GEAppliances.com
Cleanyour cooktop after
each spill. Use CERAIVlA
BRYTE®Ceramic Cooktop
Cleaner.
Normal Daily Use Cleaning
ONLYuseCERAMABRYTE®CeramicCooktop
Cleaneron the glass cooktop. Other creams
may not be as effective.
Tomaintain and protect the surface of your
glass cooktop, follow these steps:
%
Beforeusingthe cooktop for the first
time, clean itwith CERAIVlABRYTE®
Ceramic CooktopCleaner.This helps
protect the top and makes cleanup
easier.
[] Dailyuse of CERAIVlABRYTE®Ceramic
Cooktop Cleanerwill help keepthe
cooktop looking new.
J-_ Shake the cleaning cream well.Apply a
few drops of CERAIVlABRYTE®Ceramic
Cooktop Cleanerdirectly to the cooktop.
[] Usea paper towel or CERAIVlABRYTE®
Cleaning Padfor CeramicCooktops to
clean the entire cooktop surface.
[]_] Use a dry cloth or paper towel to
remove all cleaning residue. No need
to rinse.
NOTE:It is very important that you DO NOT
heat the cooktop until it has been cleaned
thoroughly.
_i ii_i_i_Iiiiiii i_ i iiiii_!i /Z)ii iii
Use a CERANABRYTE® Cleaning Pad
for Ceramic Cooktops.
Burned-On Residue
A WARNING: DAMAGEtOyour
glass surface may occur if you use scrub
pads other than those recommended.
[Z] Allow the cooktop to cool.
Spread a few drops of CERAIVlABRYTE®
Ceramic CooktopCleaneron the entire
burned residuearea.
@
Using the included CERAIVlABRYTE®
Cleaning Padfor Ceramic Cooktops, rub
the residue area, applying pressure as
needed.
%
@
If any residue remains, repeat
the steps listed above as needed.
Foradditional protection, after all
residue has been removed, polish the
entire surface with CERAMABRYTE®
CeramicCooktop Cleanerand a paper
towel.
The CERANABRYTE®Ceramic
Cooktop Scraper and all
recommended supplies are
available through our Parts
Center. See instructions under "To
Order Parts" section on next page.
NOTE:Do not use a dull or nicked
blade.
Heavy, Burned-On Residue
Allow the cooktop to cool.
Use a single-edge razor blade scraper
at approximately a 45 ° angle against
the glass surface and scrape the soil.
It will be necessary to apply pressure
to the razor scraper in order to
remove the residue.
@
After scraping with the razor scraper,
spread a few drops of CERAIVlABRYTE®
Ceramic CooktopCleaneron the entire
burned residuearea. Usethe CERAIVlA
BRYTE®Cleaning Pad to remove any
remaining residue.
%
For additional protection, after all
residue has been removed, polish the
entire surface with CERAIVlABRYTE®
Ceramic CooktopCleaner and a paper
towel.
29