Hotpoint RZA31 User Manual

FREEZER - MODELS RZA31,RZA33,RZM31,RZM33
INSTRUCTIONS FOR INSTALLATION & USE
GETTING STARTED:
To ensure that your freezer runs reliably and efficiently follow these steps.
Choose a location for your
freezer, away from any
heat sources and
allow adequate
ventilation - 30mm
(1
1
/4 inch) gap above.
Level the freezer by
adjusting the front feet.
This will stop rocking or
vibration and keep the
door aligned.
Plug in and switch on.
Allow the freezer to cool
before placing food
inside.
The high temperature
light will stay on until the
freezer has cooled down.
All food in the freezer
should be covered.
Move the freezer into
position, using the sides
of the cabinet. Take care
to avoid damaging the
refrigerant circuit pipe
work on the rear.
Before plugging in and
switching on, leave the
freezer in its final
location for at least 15
minutes to allow it to
settle.
If you are freezing fresh
food, turn on fast freeze
by pressing the switch 24
hours before placing the
food inside. Place the
fresh food inside and
remember to turn off fast
freeze after another 24
hours.
Read the rest of these instructions to get the best from your appliance
and remember to fill in your guarantee registration.
Keep this Book in a safe place for quick reference.
STEP 1
STEP 2
STEP 3 STEP 4
STEP 5 STEP 6
SAFETY &
INSTALLATION CONTROLS USEFUL ADVICE
CLEANING &
MAINTENANCE
TROUBLESHOOTING
SERVICE &
GUARANTEE
Your freezer is now
working.
If after 24 hours your
freezer is not operating as
you want, refer to the
TROUBLESHOOTING
section.
STEP 7

Hotpoint RZA31 Specifications

General

Energy Efficiency Class	A+
Appliance placement	Freestanding
Door hinge	Right
Reversible doors	Yes
Climate class	SN-T
Width	60 cm
Defrost System	Manual
Star rating	4 stars

Summary

Getting Started

STEP 1 Choose a location for your freezer

Choose a location away from heat sources with adequate ventilation (30mm gap above).

For Your Safety

General Safety Advice

Read safety advice regarding gas, ventilation, electrical devices, and proper usage.

When installing your freezer

Ensure mains cable is not trapped and avoid stacking other appliances on top.

When using your freezer

Do not sit on the freezer, store hazardous substances, or use aerosols for defrosting.

Installation

Location & Air Circulation

Position away from heat sources, allowing 30mm ventilation at the top.

Levelling

Level the freezer using front feet for stability and efficient operation.

Electrical Supply and Safety

Ensure the appliance is earthed, plug is accessible, and use correct fuse ratings.

Controls

Controlling the Temperature of the Freezer Compartment

Adjust the control wheel to set the internal freezer temperature to -18°C or colder.

Fast Freeze Button - Freezing fresh food

Details on using the Fast Freeze button for fresh food and the pre-freeze chart.

Defrosting

Fully defrosting your freezer

Step-by-step guide to defrosting, including safety precautions and water collection.

Cleaning

Interior and Exterior Cleaning

Instructions for cleaning the interior with bicarbonate of soda or sterilising fluid and the exterior.

Maintenance

Door Reversal Procedure

Detailed steps for reversing the freezer door hinge, including safety notes.

Troubleshooting

The appliance will not work

Solutions for appliance not working, checking plug, power supply, and fuse.

The freezer is too warm

The red warning light will not go out

There has been a power failure

Ice builds up rapidly inside the freezer

The door will not close

Hotpoint guarantee

Guarantee Terms and Conditions

After Sales Service

Key Contacts

Repair Service and Information Help Desk