What to do if my Hotpoint SIAL 11010 Aquarius Dishwasher does not start?
If your Hotpoint Dishwasher doesn't start, make sure the water supply tap is turned on and that the appliance is properly plugged into a working electricity socket. Also, ensure the dishwasher door is fully closed. If these steps don't work, try switching the appliance off and on again using the ON/OFF button, waiting about a minute before restarting a wash cycle.
Why is my Hotpoint SIAL 11010 Aquarius not draining water?
If water isn't draining from your Hotpoint Dishwasher, it could be due to several reasons. First, check if the wash cycle is actually finished. Also, inspect the water drain hose to ensure it isn't bent. The drain duct or the filter might also be clogged with food residues. Finally, verify the height of the drain hose according to the installation instructions.
Why are my dishes not clean after washing in my Hotpoint Dishwasher?
If your dishes aren't clean after a wash cycle in your Hotpoint Dishwasher, consider these possibilities: * The dishes may not have been arranged properly, or the sprayer arms might be blocked by the dishes, preventing their free rotation. * The selected wash cycle might be too gentle. * Too much foam could be present because the detergent wasn't measured correctly or isn't suitable for dishwashers. * The lid on the rinse aid compartment might not be closed correctly. * The filter could be dirty or clogged. The refined salt level might be low. * Also, ensure the height of the dishes is compatible with the rack adjustment and that the holes in the sprayer arms are not clogged.
Why aren't my dishes drying properly in my Hotpoint Dishwasher?
If your crockery isn't drying properly in your Hotpoint Dishwasher, it might be because a wash cycle without a drying program was selected, or the rinse aid has been used up. The rinse aid dispenser setting may also be unsuitable. Note that water drops are normal on crockery made from non-stick material or plastic.
What to do if my Hotpoint SIAL 11010 Aquarius won’t load water and has flashing lights?
If your Hotpoint Dishwasher won’t load water and shows flashing lights, check the following: * Ensure there is water in the mains supply and that the tap is open. * Inspect the water inlet hose for any bends. * Clean the filters if they are clogged. * Clear the drain duct if it's clogged. After checking and cleaning, switch the dishwasher off and on, then start a new wash cycle. If the problem persists, turn off the water tap, remove the plug, and seek professional assistance.
Why does my Hotpoint SIAL 11010 Aquarius leave a white film on dishes?
A white film or limescale deposits on dishes and glasses from your Hotpoint Dishwasher might be due to a lack of refined salt or an unsuitable water hardness adjustment; increase the relevant values. Also, the salt and rinse-aid dispenser cap may not be closed properly, or the rinse aid has been used up or the dosage is too low.
Why are my dishes streaked after washing in my Hotpoint SIAL 11010 Aquarius Dishwasher?
Streaked dishes or a bluish tinge on your dishes from your Hotpoint Dishwasher can result from a rinse aid dosage that is too high.
Why is my Hotpoint SIAL 11010 Aquarius so noisy?
Excessive noise from your Hotpoint Dishwasher can occur if dishes are rattling against each other or the sprayer arms; ensure dishes are placed properly, allowing free rotation of the sprayer arms. Also, too much foam from incorrect detergent dosage or unsuitable detergent can cause noise. Do not prewash dishes by hand.
What to do if my Hotpoint SIAL 11010 Aquarius door won’t close?
If the door of your Hotpoint Dishwasher won’t close, ensure that the racks are fully inserted. Also, make sure the lock was released and then strongly push the door until you hear a 'clacking' noise.
How to place and stabilize the dishwasher on a level floor.
Instructions for connecting the water inlet hose to the appliance.
How to connect the water outlet hose to a drain duct.
Information on the appliance's flood protection systems.
Guidance on safely connecting the appliance to the electrical socket.
Diagram and labels identifying the main parts of the dishwasher.
Explanation of the buttons, indicators, and display on the control panel.
Instructions for filling and using the salt dispenser to prevent limescale.
How to adjust the water softener based on local water hardness.
Instructions for filling and using the rinse aid dispenser for drying.
How to adjust the rinse aid dosage for optimal drying results.
Guidance on how to correctly place cutlery in the basket.
How to load delicate and lightweight items in the upper rack.
Instructions for loading pans, dishes, and larger items in the lower rack.
How to adjust compartments for optimal crockery arrangement.
List of items that should not be washed in the dishwasher.
Causes of damage and tips for preventing it.
Guidance on the correct amount of detergent for different soil levels.
Step-by-step instructions to start a wash cycle.
How to change a cycle if a mistake was made.
How to add more dishes during a running wash cycle.
Standard cycle for normal soil, most efficient for energy/water.
For heavily soiled dishes and pans.
For normally soiled pans and dishes.
For limited daily soiling, ideal for 4 place settings.
For delicate items sensitive to high temperatures.
Fast cycle for slightly dirty dishes, ideal for 2 place settings.
Pre-wash for dishes awaiting completion of the load.
Option to save water and energy for smaller loads.
Optimizes washing and drying results when using tabs.
Allows delaying the start of a wash cycle by 3, 6, or 9 hours.
Steps to safely disconnect power and water before cleaning.
How to clean the external and internal surfaces of the appliance.
Tips to avoid moisture buildup and keep the machine fresh.
How to remove and clean the spray arms to ensure proper water flow.
Instructions for cleaning the filter assembly for optimal results.
How to clean the filter at the water tap outlet.
Steps for safely storing the appliance for extended periods.
Solutions for when the appliance does not start or is not controlled.
Checks and solutions if the dishwasher door is not closing properly.
Causes and solutions for when water does not drain from the dishwasher.
Troubleshooting steps for excessive noise during operation.
Solutions for white film or limescale on dishes and glasses.
How to resolve streaking or bluish tinges on crockery.
Causes and solutions for improper drying of dishes.
Troubleshooting steps for when dishes are not washed clean.
Solutions for when the dishwasher fails to load water.
Contact information for service and support.
Information on registering the appliance for benefits.
Guidance on responsible disposal of packaging and old appliances.
Information on ordering genuine replacement parts and accessories.
Details of the standard manufacturer's guarantee.
Information on activating the extended 5-year parts guarantee.
Information on purchasing additional protection plans.
Details of free advice and assistance within the first 90 days.
General| Type | Freestanding |
|---|---|
| Number of Place Settings | 10 |
| Height | 85 cm |
| Width | 60 cm |
| Depth | 60 cm |
| Number of programmes | 6 |
| Delay Start | Yes |
| Half Load Option | Yes |
| Wash Programs | Eco, Intensive, Normal |
| Programs | Eco, Intensive, Normal |
To Next Page