EasyManua.ls Logo

HotSpring Hot Spot Propel - User Manual

HotSpring Hot Spot Propel
44 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
HOT SPOT
®
COLLECTION
RELAY
™
|
RHYTHM
™
|
PROPEL
™
|
STRIDE
™
| SX | TX
OWNER’S MANUAL 50HZ

Table of Contents

Questions and Answers

  • B
    Briana RussellAug 20, 2025
    Why is my HotSpring Hot Spot Propel Hot Tub not heating up, but the jets and light are working?
    • E
      Erin HendricksAug 20, 2025
      Your HotSpring Hot Tub might not be heating because the pressure switch is open. This can happen if the filter is clogged, preventing water flow through the heater. Check for a clogged filter to restore water flow. The pressure switch should reset once the flow is restored. If the pressure switch trips frequently, it is recommended to call for service.
  • M
    Marcus AdamsAug 22, 2025
    What to do if my HotSpring Hot Tub has cloudy water?
    • J
      Jennifer CochranAug 22, 2025
      If you have cloudy water in your HotSpring Hot Tub, it could be due to several reasons: * Dirty filters: Clean the filters. * Excessive oils or organic matter: Shock the spa with sanitizer. * Improper sanitization: Add sanitizer. * Suspended particles or organic matter: Adjust the pH and alkalinity to the recommended range. * Overused or old water: Run the jet pumps and clean the filters, or drain and refill the spa.
  • R
    Rhonda ConnerAug 25, 2025
    How to remove organic buildup or scum ring around my HotSpring Hot Spot Propel Hot Tub?
    • F
      Felicia WolfeAug 25, 2025
      An organic buildup or scum ring around your HotSpring Hot Tub is likely due to a build-up of oils and dirt. Wipe off the scum with a clean rag. If the build-up is severe, drain the spa, use a spa surface and tile cleaner to remove the scum, and then refill the spa.
  • D
    Daniel RobertsonAug 26, 2025
    What to do if my HotSpring Hot Spot Propel Hot Tub has stains?
    • V
      villarrealmorganAug 27, 2025
      Stains in your HotSpring Hot Tub can be caused by: * Total alkalinity and/or pH being too low: Adjust the total alkalinity and/or pH. * High iron or copper in the source water: Use a metal deposit inhibitor.
  • B
    billvalenzuelaAug 28, 2025
    How to fix weak jets in my HotSpring Hot Tub?
    • S
      Shawna TownsendAug 28, 2025
      Weak or surging jets in your HotSpring Hot Tub can be caused by a few things: * Low water level: Add water to the spa. * Clogged filter or suction screens: Clean the filters and suction screens. * Closed jet nozzles or air valve: Open the jet nozzles and air valve.
  • G
    gary70Aug 29, 2025
    What to do if my HotSpring Hot Tub has a bad water odor?
    • R
      robert04Aug 29, 2025
      A bad water odor in your HotSpring Hot Tub may be due to: * Excessive organics in the water: Shock the spa with sanitizer. * Improper sanitization: Add sanitizer. * Low pH: Adjust the pH to the recommended range.
  • S
    Susan MorrowAug 31, 2025
    How to fix entire inoperative HotSpring Hot Spot Propel?
    • R
      ryan14Aug 31, 2025
      If your entire HotSpring Hot Tub is inoperative, it could be due to: * A power failure: Check the power source. * A tripped GFCI: Reset the GFCI. If it won't reset, call for service.
  • C
    catherinepittmanSep 2, 2025
    Why does my HotSpring Hot Spot Propel Hot Tub have a chlorine odor?
    • A
      Ashley SimmonsSep 2, 2025
      A chlorine odor in your HotSpring Hot Tub could be caused by: * A chloramine level that is too high: Shock the spa with sanitizer. * Low pH: Adjust the pH to the recommended range.
  • I
    Ian PowersSep 4, 2025
    What does it mean when my HotSpring Hot Tub display shows “- - - - - “ and the POWER icon flashes?
    • A
      Alejandra MooreSep 4, 2025
      If your HotSpring Hot Tub display shows “- - - - - “ and the POWER icon flashes, the heater high-limit thermostat may have tripped. To reset it, disconnect power for at least thirty seconds. If it won't reset, check for a clogged filter. If it continues to trip, call for service.
  • M
    maria32Sep 6, 2025
    How to get rid of algae growth in my HotSpring Hot Tub?
    • T
      Tasha ScottSep 6, 2025
      Algae growth in your HotSpring Hot Tub can be due to: * High pH: Shock the spa with sanitizer and adjust the pH. * Low sanitizer level: Shock the spa with sanitizer and maintain the sanitizer level.

Summary

SAFETY INFORMATION

IMPORTANT SAFETY INSTRUCTIONS

Read and follow all safety instructions carefully to prevent hazards.

AVOIDING THE RISK TO CHILDREN

Precautions to prevent child drowning and injury.

AVOIDING THE RISK OF ELECTROCUTION

Safety measures to prevent electrical shock hazards.

AVOIDING THE RISK OF HYPERTHERMIA

Risks associated with excessive heat exposure in the spa.

GETTING STARTED

START-UP PROCEDURES

QUICK START-UP INSTRUCTIONS

Essential steps for initial spa setup and filling.

START-UP

Detailed instructions for filling and starting the spa.

WATER QUALITY AND MAINTENANCE

HOW TO ADD CHEMICALS TO THE WATER

Instructions for safely adding spa chemicals.

FUNDAMENTALS OF WATER MAINTENANCE

Detailed guide to testing and balancing spa water.

OPERATING INSTRUCTIONS

INSTALLATION INSTRUCTIONS

ELECTRICAL REQUIREMENTS

Important information regarding spa electrical installation.

SITE PREPARATION

Guidelines for choosing and preparing the spa location.

SPA CARE AND MAINTENANCE

DRAIN & REFILL INSTRUCTIONS

WINTERIZING YOUR SPA

FILTER CARTRIDGES REMOVAL & CLEANING

SERVICE INFORMATION

RCD AND HIGH LIMIT THERMOSTAT

ACTS INVALIDATING WARRANTY

Actions that will void the spa's warranty.

TROUBLESHOOTING

Guide to diagnosing and resolving common spa problems.

HotSpring Hot Spot Propel Specifications

General IconGeneral
Heater4kW
Filtration Area75 sq ft
Energy EfficiencyCertified to the APSP 14 national standard
Pump 11.5 HP
PumpSingle 1.5 HP
Control SystemIQ 2020®
Voltage230 V

Related product manuals