How to get rid of algae growth in my HotSpring HOT SPOT Relay Hot Tub?
Algae growth in your HotSpring Hot Tub can be due to: * High pH: Shock the spa with sanitizer and adjust the pH. * Low sanitizer level: Shock the spa with sanitizer and maintain the sanitizer level.
Why is my HotSpring HOT SPOT Relay water cloudy?
Cloudy water in your HotSpring Hot Tub can result from several factors. It may be caused by dirty filters, so cleaning them is a good first step. Excessive oils or organic matter can also be the culprit, in which case you should shock the spa with sanitizer. Other potential causes include improper sanitization (add sanitizer), suspended particles or organic matter (adjust pH and/or alkalinity), or overused water (drain and refill the spa).
Why does my HotSpring HOT SPOT Relay have a water odor?
If you notice a water odor in your HotSpring Hot Tub, it could be due to excessive organics in the water or improper sanitization; in either case, shock the spa with sanitizer or add sanitizer. Another possibility is low pH, which can be resolved by adjusting the pH to the recommended range.
What to do if my HotSpring HOT SPOT Relay Hot Tub has cloudy water?
If you have cloudy water in your HotSpring Hot Tub, it could be due to several reasons: * Dirty filters: Clean the filters. * Excessive oils or organic matter: Shock the spa with sanitizer. * Improper sanitization: Add sanitizer. * Suspended particles or organic matter: Adjust the pH and alkalinity to the recommended range. * Overused or old water: Run the jet pumps and clean the filters, or drain and refill the spa.
How to remove organic buildup or scum ring around my HotSpring Hot Tub?
An organic buildup or scum ring around your HotSpring Hot Tub is likely due to a build-up of oils and dirt. Wipe off the scum with a clean rag. If the build-up is severe, drain the spa, use a spa surface and tile cleaner to remove the scum, and then refill the spa.
How to fix entire inoperative HotSpring Hot Tub?
If your entire HotSpring Hot Tub is inoperative, it could be due to: * A power failure: Check the power source. * A tripped GFCI: Reset the GFCI. If it won't reset, call for service.
What to do if my HotSpring HOT SPOT Relay Hot Tub has a bad water odor?
A bad water odor in your HotSpring Hot Tub may be due to: * Excessive organics in the water: Shock the spa with sanitizer. * Improper sanitization: Add sanitizer. * Low pH: Adjust the pH to the recommended range.
Why does my HotSpring HOT SPOT Relay have a chlorine odor?
A chlorine odor in your HotSpring Hot Tub could be caused by: * A chloramine level that is too high: Shock the spa with sanitizer. * Low pH: Adjust the pH to the recommended range.
What causes skin irritation from HotSpring HOT SPOT Relay?
If you experience skin irritation or a rash after using your HotSpring Hot Tub, it could be due to unsanitary water or a free chlorine level above 5 ppm. To address this, shock the spa with sanitizer and maintain the sanitizer level, or allow the free chlorine level to drop below 5 ppm before using the spa.
Why does my HotSpring HOT SPOT Relay smell like chlorine?
If you notice a chlorine odor coming from your HotSpring Hot Tub, it could be due to a high chloramine level or low pH. To address this, shock the spa with sanitizer or adjust the pH to the recommended range.
General| Seating Capacity | 6 adults |
|---|---|
| Heater | 4kW |
| Dimensions | 84" x 84" x 36" |
| Filtration | Tri-X® filter |
| Cabinet Material | Polymer |
| Cover | Vinyl |
| Warranty | 5 years on shell, 2 years on components |
Essential safety advice for spa operation, including child safety and electrical hazards.
Critical information on preventing electrocution and proper grounding and GFCI testing.
Guidelines for selecting a location, ensuring a stable base, and considering environmental factors.
Detailed instructions for correctly wiring the spa, including voltage conversion and sub-panel setup.
Step-by-step guide for filling the spa, priming pumps, and initial system checks.
Explanation of the control panel layout and basic operations for jets, lights, and temperature.
Overview of filtration, sanitation, chemical balance, testing, and basic chemical safety.
Procedures for adjusting Total Alkalinity, Calcium Hardness, and pH for optimal water balance.
Procedures for cleaning the filter cartridge to ensure proper water flow and system performance.
Instructions for cleaning and maintaining the spa's acrylic shell and vinyl cover.
Procedures for draining the spa and protecting it from freezing during cold weather.
Guidelines for diagnosing and resolving common spa operational problems and when to seek professional help.
Conditions that will void the spa's limited warranty, including misuse and improper maintenance.
To Next Page
