HotSpring HOT SPOT Tempo

Questions and Answers

G
Gregory OdonnellAug 18, 2025
Why is my HotSpring HOT SPOT Tempo Hot Tub water cloudy?
- C
  Chad BarkerAug 18, 2025
  Cloudy water in your HotSpring Hot Tub can result from several factors. It may be caused by dirty filters, so cleaning them is a good first step. Excessive oils or organic matter can also be the culprit, in which case you should shock the spa with sanitizer. Other potential causes include improper sanitization (add sanitizer), suspended particles or organic matter (adjust pH and/or alkalinity), or overused water (drain and refill the spa).
K
Katie TaylorAug 20, 2025
Why does my HotSpring HOT SPOT Tempo have a water odor?
- K
  Kaitlyn McdonaldAug 20, 2025
  If you notice a water odor in your HotSpring Hot Tub, it could be due to excessive organics in the water or improper sanitization; in either case, shock the spa with sanitizer or add sanitizer. Another possibility is low pH, which can be resolved by adjusting the pH to the recommended range.
D
Daniel DuranAug 23, 2025
What to do if my HotSpring HOT SPOT Tempo Hot Tub display shows "- - - - "?
- K
  Kimberly SchneiderAug 23, 2025
  If your HotSpring Hot Tub displays “- - - - “ and the POWER icon flashes, it indicates that the heater high limit thermostat has tripped. To resolve this, disconnect power to the spa for at least thirty seconds to reset the heater. If the issue continues, try cleaning the filter. If it still occurs after cleaning the filter, call for service.
T
Tyler ArmstrongAug 26, 2025
How to fix weak jets in HotSpring HOT SPOT Tempo Hot Tub?
- M
  Mrs. Karen MillerAug 26, 2025
  If the jets in your HotSpring Hot Tub are weak or surging, there are a few potential causes. First, check the water level and add water if it's too low. Also, clogged filters or suction screens can restrict water flow, so clean them as needed. Finally, make sure the jet nozzles and air valve are open.
N
Natalie GrahamAug 28, 2025
What causes eye irritation in HotSpring HOT SPOT Tempo Hot Tub?
- O
  orobertsAug 28, 2025
  If you're experiencing eye irritation while using your HotSpring Hot Tub, it could be due to low pH or a low sanitizer level. Try adjusting the pH, and shock the spa with sanitizer while maintaining the proper sanitizer level.
A
Angelica PeckAug 30, 2025
Why does my HotSpring Hot Tub smell like chlorine?
- R
  ricardoharmonAug 30, 2025
  If you notice a chlorine odor coming from your HotSpring Hot Tub, it could be due to a high chloramine level or low pH. To address this, shock the spa with sanitizer or adjust the pH to the recommended range.
M
Megan JohnsonSep 2, 2025
How to get rid of musty odor in HotSpring Hot Tub?
- R
  Renee CareySep 2, 2025
  If your HotSpring Hot Tub is producing a musty odor, it could be caused by bacteria or algae growth. To address this, shock the spa with sanitizer. If the problem is visible or persistent, drain, clean, and refill the spa.
C
Christina HoffmanSep 5, 2025
What causes skin irritation from HotSpring HOT SPOT Tempo Hot Tub?
- B
  briannasmithSep 5, 2025
  If you experience skin irritation or a rash after using your HotSpring Hot Tub, it could be due to unsanitary water or a free chlorine level above 5 ppm. To address this, shock the spa with sanitizer and maintain the sanitizer level, or allow the free chlorine level to drop below 5 ppm before using the spa.
A
Austin ScottSep 7, 2025
How to remove scale from HotSpring HOT SPOT Tempo?
- T
  Timothy MorrisSep 7, 2025
  If your HotSpring Hot Tub has scale buildup, it's likely due to high calcium content in the water, along with total alkalinity and pH levels that are too high. Adjust the total alkalinity and pH. If scale removal is needed, drain the spa, scrub off the scale, refill it, and balance the water.
D
Dean EvansSep 9, 2025
How to clean organic buildup in HotSpring HOT SPOT Tempo?
- G
  Gerald MelendezSep 9, 2025
  If you find organic buildup or a scum ring around your HotSpring Hot Tub, it's likely caused by a buildup of oils and dirt. Wipe off the scum with a clean rag. If the buildup is severe, drain the spa, use a spa surface and tile cleaner to remove the scum, and then refill the spa.

Summary

SAFETY INFORMATION

IMPORTANT SAFETY INSTRUCTIONS

Follow all safety instructions and guidelines for proper spa operation and user safety.

CHILD SAFETY AND SUPERVISION

Guidelines to prevent child drowning and ensure supervision when using the spa.

ELECTRICAL SAFETY PRECAUTIONS

Precautions to prevent electrical shock, including proper grounding and GFCI usage.

RISK MANAGEMENT AND HEALTH ADVISORIES

ELECTRICAL SHOCK HAZARDS

Critical warnings and procedures to prevent electrical shock when operating the spa.

INJURY PREVENTION GUIDELINES

Warnings about potential injuries, including sitting in the filter area and slippery surfaces.

ADDITIONAL SPA SAFETY GUIDELINES

TEMPERATURE AND BURN RISK

Instructions to reduce injury risk related to water temperature and avoiding skin burns.

INSTALLATION INSTRUCTIONS

SITE PREPARATION

Guidelines for choosing a suitable location and preparing the site for spa installation.

ELECTRICAL INSTALLATION

SELECTING THE VOLTAGE FOR YOUR SPA

Guidance on choosing the correct voltage (115V or 230V) and amperage for spa operation.

115 VOLT INSTALLATION

Requirements for installing the spa using a 115-volt electrical circuit.

230 VOLT INSTALLATION

Requirements for installing the spa using a 230-volt electrical circuit.

ELECTRICAL INSTALLATION PROCEDURES

115 VOLT 30 AMP CONVERSION (SX & TX)

Instructions for converting SX & TX models to 115V 30A, including wiring diagrams.

230 VOLT CONVERSION, 30 OR 50 AMP (SX & TX)

Instructions for converting SX & TX models to 230V 30A/50A, including wiring diagrams.

50 AMP SUB-PANEL WIRING INSTRUCTIONS (SX & TX MODELS)

Detailed steps for wiring a 50 amp sub-panel for SX & TX models electrical connection.

230 VOLT SUBPANEL WIRING INSTRUCTIONS (TEMPO, RELAY & RHYTHM)

Wiring instructions for 230V subpanels for Tempo, Relay, and Rhythm models.

30 AMP SUB-PANEL WIRING INSTRUCTIONS

Detailed steps for wiring a 30 amp sub-panel for spa electrical connection.

SPA SPECIFICATIONS & ILLUSTRATION

OPERATING INSTRUCTIONS

START-UP AND REFILL PROCEDURES

Step-by-step guide for safely filling and starting up your new Hot Spot spa.

OPERATING CAUTIONS

SPA OPERATION DETAILS

HEATING AND HYDROMASSAGE SYSTEMS

Explanation of how the spa's heating and jet pump systems work, including dual-speed operation.

SPA CONTROL PANEL FUNCTIONS

SAFETY EQUIPMENT CHECK

Testing procedures for GFCI and understanding high-limit thermostat functions for spa safety.

JET PUMP CONTROL

How to control the jet pump speeds and functions using the control panel buttons.

PRESSURE AND CONTROL THERMOSTAT

LIGHT CONTROL

Operating the spa light, adjusting brightness, and automatic shut-off features.

TEMPO, RELAY, RHYTHM CONTROL PANEL

Overview of control panel features for Tempo, Relay, and Rhythm models.

SYSTEM MODE AND CLEANING MODE

TOOLS MENU AND LOCKING FEATURES

TEMPERATURE CONTROL OPERATION

How to set and adjust the spa water temperature using the control panel.

SX & TX MODELS SPA CONTROL PANEL

SX;TX TEMPERATURE CONTROL

Setting and adjusting the water temperature on SX & TX model control panels.

OPERATING INSTRUCTIONS

TEMPERATURE LOCK AND SPA LOCK

SX;TX JET PUMP CONTROL

Controlling jet pump speeds and functions on SX & TX models.

FILTER CYCLES ADJUSTMENT

SX;TX LIGHT CONTROL

Operating the spa light, adjusting brightness, and automatic shut-off features on SX & TX models.

SX;TX SYSTEM MODE AND CLEANING MODE

SX;TX TOOLS MENU AND LOCKING FEATURES

WATER QUALITY AND MAINTENANCE

GENERAL INFORMATION

Overview of the three fundamental areas of spa water maintenance: filtration, sanitation, and balance.

ADMINISTERING SPA WATER CHEMICALS

BALANCING THE PH

FRESHWATER AG+ SILVER ION SYSTEM

HOT SPOT WATER TREATMENT GUIDE

A guide for chemical dosages for spa startup, weekly maintenance, and as needed treatments.

TESTING SPA WATER METHODS

Methods for accurately testing spa water chemistry, including TA, CH, pH, and sanitizer levels.

SPA WATER MAINTENANCE PROGRAM

A comprehensive program for maintaining balanced and clean spa water chemistry.

MAINTAINING SANITIZER LEVEL

EVERFRESH WATER CARE SYSTEM

BASIC CHEMICAL SAFETY

Essential safety guidelines for handling and using spa chemicals properly.

FILLING SPA WITH WATER

WATER QUALITY DOS AND DONTS

ADDING CHEMICALS TO WATER

Procedure for adding chemicals to the spa water, emphasizing proper placement and pump operation.

BALANCING TOTAL ALKALINITY (TA)

BALANCING CALCIUM HARDNESS (CH)

MAINTENANCE AND SPA CARE

FILTER CARTRIDGE REMOVAL AND CLEANING

PREVENTION OF FREEZING

FILTER MAINTENANCE

WINTERIZING YOUR SPA

Comprehensive instructions for properly winterizing the spa to prevent damage from freezing.

DRAINING YOUR SPA

OPENING INSTRUCTIONS

NON-OPERATION IN COLD CLIMATE

SERVICE INFORMATION

GENERAL SERVICE INFORMATION

ACTS INVALIDATING WARRANTY

GENERAL OPERATION TROUBLESHOOTING

Troubleshooting guide for common operational issues like no power, no heat, or weak jets.

PRIMING THE PUMP(S)

GFCI AND HIGH-LIMIT THERMOSTAT ISSUES

Troubleshooting steps for GFCI and high-limit thermostat issues affecting spa operation.

SPA WATER MAINTENANCE TROUBLESHOOTING

Troubleshooting common spa water problems like cloudy water, odor, and stains.

MISCELLANEOUS SERVICE INFORMATION

TROUBLESHOOTING OVERVIEW

Tips and guidance for diagnosing and resolving common spa problems.