How to remove stains from HotSpring HOT SPOT Tempo?
If your HotSpring Hot Tub has stains, it could be because the total alkalinity and/or pH are too low, adjust them. Alternatively, there might be high iron or copper content in your source water, so use a metal deposit inhibitor.
What to do if HotSpring Hot Tub jets not working after refill?
If, after filling or refilling your HotSpring Hot Tub, a jet pump is operating but water isn't flowing from any of its jets, the pump may not be properly primed. Turn off power to the spa at the breaker and remove the equipment compartment door. Loosen the union on top of the pump to allow air to escape, then hand-tighten it. Turn the power back on, activate the pump, and ensure the union is tight enough to prevent leaks. Re-install the pump and equipment doors.
Follow all safety instructions and guidelines for proper spa operation and user safety.
Guidelines to prevent child drowning and ensure supervision when using the spa.
Precautions to prevent electrical shock, including proper grounding and GFCI usage.
Critical warnings and procedures to prevent electrical shock when operating the spa.
Warnings about potential injuries, including sitting in the filter area and slippery surfaces.
Instructions to reduce injury risk related to water temperature and avoiding skin burns.
Guidelines for choosing a suitable location and preparing the site for spa installation.
Guidance on choosing the correct voltage (115V or 230V) and amperage for spa operation.
Requirements for installing the spa using a 115-volt electrical circuit.
Requirements for installing the spa using a 230-volt electrical circuit.
Instructions for converting SX & TX models to 115V 30A, including wiring diagrams.
Instructions for converting SX & TX models to 230V 30A/50A, including wiring diagrams.
Detailed steps for wiring a 50 amp sub-panel for SX & TX models electrical connection.
Wiring instructions for 230V subpanels for Tempo, Relay, and Rhythm models.
Detailed steps for wiring a 30 amp sub-panel for spa electrical connection.
Step-by-step guide for safely filling and starting up your new Hot Spot spa.
Explanation of how the spa's heating and jet pump systems work, including dual-speed operation.
Testing procedures for GFCI and understanding high-limit thermostat functions for spa safety.
How to control the jet pump speeds and functions using the control panel buttons.
Operating the spa light, adjusting brightness, and automatic shut-off features.
Overview of control panel features for Tempo, Relay, and Rhythm models.
How to set and adjust the spa water temperature using the control panel.
Setting and adjusting the water temperature on SX & TX model control panels.
Controlling jet pump speeds and functions on SX & TX models.
Operating the spa light, adjusting brightness, and automatic shut-off features on SX & TX models.
Overview of the three fundamental areas of spa water maintenance: filtration, sanitation, and balance.
A guide for chemical dosages for spa startup, weekly maintenance, and as needed treatments.
Methods for accurately testing spa water chemistry, including TA, CH, pH, and sanitizer levels.
A comprehensive program for maintaining balanced and clean spa water chemistry.
Essential safety guidelines for handling and using spa chemicals properly.
Procedure for adding chemicals to the spa water, emphasizing proper placement and pump operation.
Comprehensive instructions for properly winterizing the spa to prevent damage from freezing.
Troubleshooting guide for common operational issues like no power, no heat, or weak jets.
Troubleshooting steps for GFCI and high-limit thermostat issues affecting spa operation.
Troubleshooting common spa water problems like cloudy water, odor, and stains.
Tips and guidance for diagnosing and resolving common spa problems.
To Next Page
General