How to prevent eye irritation in my HotSpring HIGHLIFE SOVEREIGN?
Eye irritation in your HotSpring Hot Tub can result from low pH or low sanitizer levels. Adjust the pH, shock the spa with sanitizer and maintain the sanitizer level.
What to do if my HotSpring Hot Tub water smells bad?
If your HotSpring Hot Tub water has an odor, it could be due to excessive organics, improper sanitization, or low pH. To address this: * Shock the spa with sanitizer. * Add sanitizer. * Adjust the pH to the recommended range.
Why does my HotSpring HIGHLIFE SOVEREIGN Hot Tub have a chlorine odor?
A chlorine odor in your HotSpring Hot Tub usually indicates a high chloramine level or low pH. Try these solutions: * Shock the spa with sanitizer. * Adjust the pH to the recommended range.
What to do if my HotSpring HIGHLIFE SOVEREIGN touchscreen continuously reads "Searching for spa"?
If the touchscreen on your HotSpring Hot Tub continuously reads "Searching for spa", it means the remote is not paired. Press the Jets button on the DOCK until the dock buttons flash, then press and hold the screen until Pairing Yes/No is displayed. Finally, press Yes to pair.
How to remove organic buildup or scum ring around my HotSpring HIGHLIFE SOVEREIGN?
An organic buildup or scum ring around your HotSpring Hot Tub is typically caused by a build-up of oils and dirt. Wipe off the scum with a clean rag. If the problem is severe, drain the spa, use a spa surface and tile cleaner to remove the scum, and then refill the spa.
What does it mean when the Blue Logo "Power" indicator is blinking on my HotSpring HIGHLIFE SOVEREIGN?
If the Blue Logo "Power" indicator is blinking on your HotSpring Hot Tub, it indicates that the heater high-limit thermostat has tripped. To resolve this, disconnect power for at least thirty seconds to reset the heater high limit. If it doesn't reset, check for clogged filters.
How to get rid of musty odor in HotSpring HIGHLIFE SOVEREIGN Hot Tub?
A musty odor in your HotSpring Hot Tub is usually caused by bacteria or algae growth. Shock the spa with sanitizer. If the problem is visible or persistent, drain, clean, and refill the spa.
How to remove stains from my HotSpring HIGHLIFE SOVEREIGN Hot Tub?
Stains in your HotSpring Hot Tub can be caused by low total alkalinity and/or pH, or high iron or copper in the source water. To address this, adjust the total alkalinity and/or pH. You can also use a metal deposit inhibitor.
What does it mean when the Green Logo "Ready" indicator is blinking on my HotSpring HIGHLIFE SOVEREIGN Hot Tub?
If the Green Logo "Ready" indicator is blinking on your HotSpring Hot Tub, it indicates a temperature sensor problem. Disconnect power for at least thirty seconds. If blinking continues, call for service.
How do I fix scale buildup in my HotSpring HIGHLIFE SOVEREIGN?
Scale buildup in your HotSpring Hot Tub is usually due to high calcium content in the water, along with high total alkalinity and pH. To resolve this: * Adjust the total alkalinity and pH. * If scale removal is required, drain the spa, scrub off the scale, refill it, and balance the water.
Essential safety guidelines for spa operation and user protection.
Safety measures to prevent electrical shock hazards.
Key guidelines for spa use, maintenance, and care.
Safe handling and use of spa chemicals.
Step-by-step guide for draining and refilling the spa.
Troubleshooting issues related to RCD and high limit thermostat.
Actions that will void the spa's limited warranty.
Guide for diagnosing and resolving common spa problems.
To Next Page
General