2
4 205 118 / 01
Table of contents
1. Important information
1.1 Other instructions ................................................................................................................................... 3
1.2 Safety instructions .................................................................................................................................. 3
1.3 Regulations, official approvals .............................................................................................................. 3
1.4 Warranty ................................................................................................................................................... 4
2. Assembly
2.1 Installation position ................................................................................................................................ 5
2.2 Setting up, levelling ................................................................................................................................ 5
2.3 Fitting the heat insulation ...................................................................................................................... 6
2.4 Fitting the casing .................................................................................................................................... 8
2.5 Fitting the boiler controller on the side ................................................................................................ 8
2.6 Fitting the boiler controller at the top ................................................................................................. 10
3. Technical information
3.1 Description of the boiler ....................................................................................................................... 12
3.1.1 The Uno-3 (130-280) complies with the following directives + standards ............................................... 12
3.2 Technical data Uno-3 (130-280) ............................................................................................................ 13
3.3 Dimensions ............................................................................................................................................ 14
3.4 Dimensions without heat insulation and casing (transport dimensions) ........................................ 14
4. Installation
4.1 Boiler room requirements .................................................................................................................... 15
4.2 Connection of the flue gas system and flue duct dimensions ......................................................... 15
4.3 Fitting the burner .................................................................................................................................. 17
4.3.1 Sound insulation ...................................................................................................................................... 17
4.4 Fuel ......................................................................................................................................................... 18
4.5 Electrical connection ............................................................................................................................ 18
4.5.1 Electrical connection of the burner .......................................................................................................... 18
4.6 Flue gas regulator set ........................................................................................................................... 18
4.6.1 Flue gas and performance diagrams ...................................................................................................... 19
4.7 Flow mixing loop / minimum limitation of the boiler return temperature ........................................ 21
4.8 Setting the temperature regulators ..................................................................................................... 21
4.9 Safety valves ......................................................................................................................................... 21
4.10 Charging pump (boiler with free-standing calorifier) ........................................................................ 21
4.11 Heating pump ........................................................................................................................................ 21
5. Commissioning
5.1 Water quality .......................................................................................................................................... 22
Heating water .......................................................................................................................................... 22
Filling and replacement water ................................................................................................................. 22
5.2 Filling the heating system .................................................................................................................... 23
5.3 Filling the calorifier (if present) ........................................................................................................... 23
5.4 Initial commissioning ........................................................................................................................... 23
5.5 Oil/gas burner ........................................................................................................................................ 23
5.6 Handover to the operator / storage ..................................................................................................... 23
6. Maintenance
6.1 Information for fire inspector / chimney sweep regarding emission monitor key .......................... 24
6.2 Cleaning ................................................................................................................................................. 25
6.2.1 Preparatory work ..................................................................................................................................... 25
6.2.2 Cleaning (dry or wet method) .................................................................................................................. 25
6.2.3 Putting into operation again .................................................................................................................... 25
7. Overview of settings
7.1 Table of parameters .............................................................................................................................. 26
7.2 Overview of alarms TopTronic
®
T .......................................................................................................... 36
To Next Page
Loading...
Need help?
General