If you have questions or concerns about any of these steps, please feel free to contact our Customer Service
Team at www.hover-1.com. A representative will be in touch to walk you through these steps.
Carefully follow the steps shown on the following pages for installing the Hover-1 Falcon-1 onto your electric
scooter. Read this entire manual before riding your Hover-1 Falcon-1.
Your Hover-1 Falcon-1 must be completely assembled before installing it onto your electric scooter. Please
refer to the “Assembling your Hover-1 Falcon-1” section for assembling procedures.
1. Place the pedal mounts onto the footpad sensors of your self-balancing scooter with the front wheel
facing forward. Ensure the pedal mounts are centered on the footpad sensors of your scooter as much
as possible.
INSTALLING YOUR HOVER-1 FALCON-1
Please visit
www.hover-1.com/troubleshoot
to request missing
or defective parts
SPACE EVENLY
10
To Next Page
Loading...
