Please visit
www.hover-1.com/troubleshoot
to request missing
or defective parts
RUBBER PROTECTORS HOOK & LOOP STRAP
ASSEMBLY DIRECTIONS
LOCATION OF RUBBER
PROTECTORS
2. Using two Hook and Loop straps, attach one end of each Hook and Loop strap to the holes on the front of
each pedal mount as shown below.
3. Wrap both hook and loop straps under your self-balancing scooter and attach the ends to the hooks on
the back of each pedal mount. The rubber protective straps should be centered underneath the
hoverboard, with side B facing the ground. One set of rubber protective straps should come pre-assembled
with the hook and loop straps.
A
B
11
To Next Page
Loading...
