PLEASE READ THE FOLLOWING INSTRUCTIONS CAREFULLY
ATTACHING THE HANDLEBAR ASSEMBLY
Attach the handlebar assembly by placing it into the steering column,
aligning the front and back bolt holes, and tightening the 4 bolts into
place with the hex key.
• Ensure that the charging port is clean and dry.
• Make sure that there is no dust, debris or dirt inside the port.
• Plug the charger into a grounded wall outlet.
• Connect the cable with the power supply (100V-240V; 50 Hz/60 Hz).
• Align and connect the 1-pin charging cable into the charging port
of the Journey Max (DO NOT FORCE OR BEND THE CHARGING
CABLE AS IT MAY CAUSE THE PRONGS TO BEND OR BREAK).
• The charging indicator light on the charger itself should change to
red, indicating that your device is now being charged.
• When the red indicator light on your charger changes to green,
then your device is fully charged.
• After fully charging your Journey Max, unplug the charger from
your device and from the power outlet.
Only use the included charging
cable and charger to charge
your Journey Max. Using any
other charger may damage your
Journey Max.
CAUTION
CHARGING YOUR JOURNEY
PREPARING YOUR E-SCOOTER
17
x4
To Next Page
Loading...
