16 Hoverzon
TM
Cruiser Folding E-Scooter User’s Manual
2.6 CHARGING INSTRUCTIONS
CHARGE THE CRUISER BEFORE USING IT. DO NOT under any circumstances use the
Cruiser while it is charging or connected to the charger.
The charging time is approximately 1.5 hours. Charging longer than necessary may
affect battery life and/or performance. If the charger’s light doesn’t turn on when
charging, it may not be fully connected. Please ensure it is securely connected to
the wall and to the Cruiser.
The charge cycle is complete when the battery icon on the display is full and/or the charger’s light is
green. After this initial charge, use the Cruiser until battery level reaches approximately 10% (Battery
Level Indicator will show one bar) before recharging.
Each charge cycle from zero to full charge will take approximately 1.5 hrs. When the backlit display on
the handlebars indicates battery power is low, recharge the Cruiser. To recharge the Cruiser, use the
included charging cable and its adapter.
Step 1. Make sure the Cruiser is turned off before charging and remains off while charging.
Step 2. Remove the cap covering the charging port.
Step 3. Insert the appropriate end into the Cruiser’s stand and then fully insert other end into a
wall outlet.
Step 4. While the Cruiser is charging, the charger light will turn red.
Step 5. When the Cruiser is fully recharged, the charger light will turn green. You may then disconnect
the Cruiser from the charger.
WARNING
CAUTION
To Next Page
Loading...