20 Hoverzon
TM
Cruiser Folding E-Scooter User’s Manual
Powered Acceleration Start
This is the default start setting. Follow the instructions below.
Step 1. Press the POWER button for 2 seconds to turn the Cruiser on.
Step 2. Carefully step on with one foot and stand upright but relaxed.
Step 3. Balance with both feet on the Cruiser and use the throttle to start powered acceleration.
Step 4. To stop riding, release the throttle and use the handbrake, footbrake, or both to gradually
coast to a stop then step off the Cruiser one foot at a time. Be extra cautions when dismounting for
the fi rst time.
Manual Acceleration Start
To use this start setting, please refer to P04 on page 14 then follow the instructions below.
Step 1. Press the POWER button for 2 seconds to turn the Cruiser on.
Step 2. Carefully step on with one foot and stand upright but relaxed.
Step 3. Keep one foot on the ground and kick off to begin accelerating manually.
Step 4. Once the Cruiser reaches 4mph (6 km/h), press the throttle to start powered acceleration.
Step 5. To stop, release the throttle and use the handbrake, footbrake, or both to gradually coast to a
stop then step off the Cruiser one foot at a time. Be extra cautious when dismounting for the fi rst time.
Cruise Control
Step 1. Accelerate to reach the desired speed.
Step 2. Hold the throttle for approximately 6 seconds to turn on Cruise Control and maintain speed.
Step 3. Use the throttle or the handbrake to turn off Cruise Control.
To Next Page
Loading...