Problem
Possible
Causes
Remedy
Pressure
drops
during use
Water
intake from
external
tank
Connect appliance
to the mains water
supply
Intake water
too hot
Reduce
temperature
Nozzle
clogged
Clean nozzle (fig.19)
Motor
‘sounds’
but fails to
start
Insufficient
power
supply
Check that the
voltage of the
mains power supply
line is the same as
that on the plate
(fig.9)
Voltage loss
due to use
of extension
cable
Check
characteristics of
extension cable
Appliance
not used for
along period
of time
Contact Hozelock
Consumer Services
on 0121 313 1122
Problems
with TSS
device
Contact Hozelock
Consumer Services
on 0121 313 1122
Motor fails
to start
No electrical
power
Check that the
plug is firmly in the
socket and that
the mains voltage
supply is present
Problem
with TSS
device
Contact Hozelock
Consumer Services
on 0121 313 1122
Water
leakage
Seals worn Contact Hozelock
Consumer Services
on 0121 313 1122
Appliance
noisy
Water too
hot
Reduce
temperature
(see technical data)
Oil leakage Seals worn Contact Hozelock
Consumer Services
on 0121 313 1122
Motor
starts even
with gun
trigger is
released
Nozzle
clogged
Clean nozzle (fig.19)
High
pressure
system
or pump
hydraulic
circuit not
watertight
Contact Hozelock
Consumer Services
on 0121 313 1122
Problem
Possible
Causes
Remedy
No water
delivery
when gun
trigger is
depressed
(with
supply
hose
connected)
Nozzle
clogged
Clean nozzle (fig.19)
If the motor starts and does not restart during
operation, wait 2-3 minutes before repeating
the start-up procedure (overload cutout has
been tripped).
If the problem recurs more than once, call
Hozelock Consumer Services on 0121 313 1122.
To Next Page
Loading...
