Hozelock 7902 - Electrical Safety; General Information; Technical Information; Intended use

Electrical Safety
If you have to replace the fuse, only those
that are ASTA or BSI approved to BS 1362
and with a rated current of 13 amps should
be used. If there is a fuse cover fitted, this
cover must be refitted after changing the
fuse. If the fuse cover is lost or damaged, the
plug must not be used. Spare fuse holders
and fuses are available from electrical
outlets.
If the power supply cord or plug becomes
damaged in any way, it should be replaced
by a suitably qualified person. A replacement
plug should be wired according to the
following instructions.
IMPORTANT THIS APPLIANCE MUST BE
EARTHED: As the colours of the wires in the
mains lead of this product may not
correspond with the colours or markings
identifying the terminals in your plug, you
should proceed as follows:
The green/yellow lead should be connected
to the EARTH terminal which may be marked
with an ‘E’ or coloured green or green/
yellow.
The wire that is coloured blue must be
connected to the NEUTRAL terminal which
may be marked with the letter N or coloured
blue or black.
The wire that is coloured brown must be
connected to the LIVE terminal which may be
marked with the letter L or coloured brown
or red.
If in doubt, contact a qualified electrician.
General Information
•Thismanualformsanintegralpartofthe
appliance and should be kept for future
reference. Please read it carefully before
installing/using the unit. If the appliance is
sold, the Seller must pass on this manual to the
new owner along with the appliance.
Disposing of packaging
•Please dispose of all packaging in an
environmentally responsible way.
Safety signs
•Comply with the instructions provided by the
safety signs fitted to the appliance. Check that
they are present and legible; otherwise, fit
replacements in the original positions.
Technical Information
Intended use
•This appliance has been designed for individual
use for the cleaning of vehicles, machines,
boats, masonry, etc, to remove stubborn dirt
using clean water and biodegradable chemical
detergents. Vehicle engines may be washed
only if the dirty water is disposed of as per
regulations in force.
•Intakewatertemperature:seedataplateon
the appliance.
•Intakewaterpressure:Max10bar,Min1bar.
•Operatingambienttemperature:above0°C.
The appliance is compliant with the
EN 60335-2-79/A1 standard.
Improper use
•Use by unskilled persons or those who have
not read and understood the instructions in
the manual is forbidden. The introduction of
inflammable, explosive and toxic liquids into
the appliance is prohibited.
•Useoftheapplianceinapotentially
inflammable or explosive atmosphere is
forbidden. The use of non-original spare parts
and any other spare parts not specifically
intended for the model in question is
prohibited. All modifications to the appliance
are prohibited. Any modifications made to
the appliance shall render the Declaration
of Conformity null and void and relieve the
manufacturer of all liability under civil and
criminal law.
Safety devices
CAUTION - DANGER! Do not tamper with or
adjust the safety valve setting.
•Thesafetyvalveisalsoapressurelimiting
valve. When the gun trigger is released, the
valve opens and the water recirculates through
the pump inlet.
•Safetybutton(X):preventsaccidentalspraying
ofwaterbypressingtheredsafetybutton(X)
into locking position (fig.11).
Installation
Assembly
CAUTION - DANGER! All installation and
assembly operations must be performed
with the appliance disconnected from the
mains power supply. As illustrated in the
Assembly & Operation’ diagrams.