To Next Page

To Previous Page

Preparing the rack for component installation 13

Removing the rear doors

1. Unlock the doors and open them.

2. Open the hinge brackets (1) by pulling up on the top hinge pin and pulling down on the bottom

hinge pin for each door.

3. Lift the rear doors off of the hinge brackets, and remove them from the rack (2). Store the doors in an

upright position, taking care to protect them from damage.

Removing the side panels

NOTE: The side panels come preinstalled on all HP 10622 G2 Racks.

Other manuals for HP 10000 G2 Series

Questions and Answers:

Need help?

Do you have a question about the HP 10000 G2 Series and is the answer not in the manual?

General