HP 11

The following instructions apply solely to the HP 11 Notebook PC. *
Enabling Battery Safety Mode
1. When the BIOS installation completes, follow the instructions to restart your computer.
2. When the HP logo appears, press F10 to enter BIOS Setup.
3. Select 'System Configuration' tab using Right Arrow key. Look for the item "Battery Safety
Mode" and change the setting to "Enabled" using F5/F6 key.
4. Go to "Exit" Tab by Right Arrow Key and choose "Exit Saving Changes". Press the Enter key and
Select "Yes" in the dialog.
5. After system restart, the BIOS displays the following Message. Select "Accept".
6. After you restart your computer again, the battery will be put into Safety Mode.
7. You will be required to use your HP Power Adapter after accepting Battery Safety Mode.
Disabling Battery Safety Mode

HP 11 Specifications

General

Operating System	ChromeOS
Display Size	11.6 inches
Display Resolution	1366 x 768
RAM	4 GB
Wireless	802.11ac
Ports	1 x Headphone/Microphone Combo
Weight	1.14 kg

Summary

Enabling Battery Safety Mode

Configure BIOS for Battery Safety Mode

Change 'Battery Safety Mode' to 'Enabled' in BIOS System Configuration.

Accept Battery Safety Mode Warning

Acknowledge the system message to accept Battery Safety Mode for continued use.

Battery Safety Mode Operation

After enabling, the battery enters Safety Mode; HP Power Adapter is required.

Disabling Battery Safety Mode

Disable Battery Safety Mode in BIOS

Set 'Battery Safety Mode' to 'Disabled' in BIOS System Configuration.

Save Changes and Resume Normal Operation

Exit BIOS after disabling Safety Mode to restore normal battery functionality.