6 Getting Started
Digit separator
(page 35)
In the number shown in the above image, the digit
separator is a comma (,). The decimal point is a point (.)
These are the default settings. To change the digit
separator from a comma to a period:
1. P r e s s
E.
2. Specify the decimal point as either a point (.), or a
comma (,).
3. Pressing (,) specifies the decimal point as a comma (,)
and a point (.) as the digit separator (see below).
Note: You may set the digit separator from within a menu
or during calculations. If you are working within the
Business menu (BUS) for example, and you press
E to
set the digit separator, after your selection in the steps
above, the calculator returns you to the BUS menu. If you
are performing a calculation, you are returned to current
work.
Table 1-1
Functions Display/Description
To Next Page
Loading...
Need help?
General
