8. Remove the hard drive (2) from the hard drive cage.
Reverse this procedure to install the hard drive and hard drive cage.
Memory module
1. Prepare the computer for disassembly (see Preparation for disassembly on page 13).
2. Remove the stand assembly (see Stand assembly on page 14).
3. Remove the rear cover (see Rear cover on page 15).
4. Spread the retaining tabs (1) on each side of the memory module slot to release the memory module.
(The memory module tilts up.)
5. Remove the memory module (2) by pulling it away from the slot at an angle.
Reverse this procedure to install a memory module.
Memory module 17
To Next Page
Loading...
