HP 210 G1 User Manual

111 pages

To Next Page

To Previous Page

3. Remove the WLAN module (3) by pulling the module away from the slot at an angle.

NOTE: If the WLAN antenna cables are not connected to the terminals on the WLAN module, the

protective sleeves must be installed on the antenna connectors, as shown in the following illustration.

Reverse this procedure to install the WLAN module.

Component replacement procedures 45

Other manuals for HP 210 G1

Need help?

Do you have a question about the HP 210 G1 and is the answer not in the manual?

General