ENWW Chapter 6 Removal and replacement 145
E-label reader
1 Remove all of the covers and the control-panel assembly (see pages 113 through 124).
2 Remove the laser/scanner plate (page 144).
3 Unwind the e-label reader cable (callout 5) from the cable holders that are on top of the
laser/scanner plate.
Note Examine the cable routing. Make sure that you loop the cable around the vertical cable holder
(callout 6) when you reinstall the e-label reader.
Figure 70. Removing the e-label reader (2 of 3)
2
2
6
5
To Next Page
Loading...