To Next Page

To Previous Page

Connecting the HDMI Cable (Select Models)

Connect one end of the HDMI cable to the back of the monitor and the other end connector to the input

device. The HDMI cable is included with select models.

NOTE: The audio stream must be connected directly to external speakers or to an audio receiver.

Figure 3-5 Connecting the HDMI Cable (cable provided with select models only)

Getting HDMI Sound

If you use HDMI to connect to a monitor model without speakers, you must activate HDMI sound by

adjusting the setting in Microsoft Windows. If HDMI is not activated, you can not hear any sound. To

activate HDMI sound on your computer:

1. Right-click on the volume icon in the Windows system tray.

2. Click Playback Devices. The sound window opens.

3. On the Playback tab, click the HDMI output audio device that is listed.

4. Click Set Default.

5. Click Apply.

6. Click OK to close the window.

10 Chapter 3 Setting Up the Monitor

Downloaded from ManualMonitor.com Manuals

Questions and Answers:

Need help?

Do you have a question about the HP 2311x and is the answer not in the manual?

HP 2311x Specifications

General

3D	No
Pixel pitch	0.265 x 0.265 mm
Display diagonal	23 \
Viewing angle, vertical	160 °
Contrast ratio (dynamic)	3000000:1
Contrast ratio (typical)	1000:1
Display number of colors	-
Viewing angle, horizontal	170 °
Display brightness (typical)	250 cd/m²
HDCP	Yes
USB Type-A downstream ports quantity	0
Product color	Black
Country of origin	China
Tilt angle range	0 - 25 °
Cable lock slot type	Kensington
Panel mounting interface	- mm
Power consumption (standby)	0.6 W
Power consumption (typical)	33 W