4. Apply thermal paste on the system board component (1) and heat sink (2).
Reverse this procedure to reassemble and install the heat sink assembly.
Display assembly
To remove the display assembly, use this procedure and illustration.
Table
5-17 Display assembly part descriptions and part numbers
Description Spare part number
Hinge cover M23371-001
Display bezel L24465-001
Webcam/microphone module
HD L23237-001
VGA L23238-001
Raw display panel
FHD, antiglare, UWVA M28173-001
HD, antiglare, WLED SVA M28174-001
Hinges (left and right) L24470-001
Display cable
HD display L24492-001
FHD display L24493-001
Antennas
Dual L24640-001
Single L29012-001
Display enclosure
46 Chapter 5 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
