Solid-state drive (SSD)
Description Spare part number
Solid-state drive, 256-GB, M.2 760615-030
Solid-state drive, 128-GB, M.2, for use in HP Notebook PC models 827560-021
Solid-state drive, 128-GB, M.2, for use in HP 250/256 G5 Notebook PC models 861334-001
Solid-state drive, 128-GB, M.2, for use in HP 250/256 G5 Notebook PC models 861335-001
Before removing the solid-state drive, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is o or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by rst unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the battery (see Battery on page 38).
5. Remove the optical drive (see Optical drive on page 39), if installed.
6. Remove the bottom cover (see Bottom cover on page 42).
Remove the solid-state drive:
1. Remove the Phillips PM2.0×2.0 screw (1) that secures the drive to the system board.
2. Remove the drive (2) by pulling it away from the connector.
NOTE: Solid-state drives are designed with notches to prevent incorrect insertion.
Reverse this procedure to reassemble and install the solid-state drive.
Component replacement procedures 55
To Next Page
Loading...
