4
16. cd ..
17. tar -xzvf xen-3.3.0.tar.gz
18. cd xen-3.3.0
19. make install-xen
20. make install-tools
21. edit the menu file (/boot/grub/menu.lst) as follows:
Before the ‘title’ add:
serial --unit=0 --speed=115200 --parity=no --stop=1
terminal --timeout=10 serial console
Add an additional grub entry:
title Fedora Core (Xen with VTD)
root (hd0,0)
kernel /xen.gz com1=115200,8n1 vtd=1 console=com1
module /vmlinuz-2.6.18.8-xen root=LABEL=/ ro console=tty0 console=ttyS0, 115200,
8n1 pci=nommconf (All in a single line)
module /initrd-2.6.18.8-xen.img
22. Make sure to check the root location and ‘root=LABEL=/’ match with the first grub entry and points
to the root partition.
23. Reboot the system. Enable TPM, VTD and TXT in the Bios settings.
24. The next time you boot into the system, you can select the option at the boot menu to boot into
‘Xen with VTD’.
25. While checking the serial output for this grub entry, if it gets stuck at a display message related to
VTD, then try ‘vtd=0’ in the grub entry.
TBOOT Installation
1. Copy the latest sinit.bin file into /boot directory.
2. Open the terminal
3. cd ~/
4. If required set the proxy options as, export http_proxy=<proxy address>:<port number>
5. yum install mercurial (if not installed already)
6. hg clone –r 93d0895153f6 http://www.bughost.org/repos.hg/tboot.hg (this downloads latest
tboot package)
7. cd tboot.hg/tboot
8. edit Config.mk, un-comment (remove #) the line #CFLAGS += -DMEM_LOGGING and save it
(This will write all of the serial messages to a memory buffer. Helpful for notebooks that lack serial
output port).
9. cd ..
10. make install (requires internet connection)
11. cd ..
12. ln –s linux-2.6.18-xen-3.3.0 build-linux-2.6.18-xen_x86_64 (assuming Xen is already installed)
To Next Page
Loading...
Need help?
General
