EasyManua.ls Logo

HP 2615 series User Manual

HP 2615 series
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #16 background imageLoading...
Page #16 background image
2-550 m (multimode 62.5 µm core diameter, 500 MHz*km bandwidth)
2-550 m (multimode 50 µm core diameter, 400 MHz*km bandwidth)
2-550 m (multimode 50 µm core diameter, 500 MHz*km bandwidth)
2-10,000 m (single-mode fiber)
Notes
A mode conditioning patch cord may be needed in some multimode fiber
installations.
Wavelength: 1310nm
Power Consumption: < 500mW Typical
Services
Refer to the HP website at
www.hp.com/networking/services
for details on the
service-level descriptions and product numbers. For details about services and
response times in your area, please contact your local HP sales office.
HP X121 1G SFP LC LH
Transceiver
(J4860C)
A small form-factor
pluggable (SFP) Gigabit LH
transceiver that provides a
full-duplex Gigabit solution
up to 70 km on single-
mode fiber.
Ports
1 LC 1000BASE-LH port (no IEEE standard exists for 1550 nm optics); Duplex:
full only
Physical characteristics
Dimensions: 2.17(d) x 0.60(w) x 0.46(h) in. (5.5 x 1.53 x 1.18 cm)
Weight: 0.04 lb. (0.02 kg)
Environment
Operating temperature: -40°F to 185°F (-40°C to 85°C)
Operating relative humidity: 0% to 95% @ 77°F (25°C), noncondensing
Nonoperating/Storage temperature: -40°F to 185°F (-40°C to 85°C)
Altitude: up to 10,000 ft. (3 km)
Cabling
Cable type:
Low metal content, single-mode fiber-optic, complying with ITU-T
G.652 and ISO/IEC 793-2 Type B1;
Maximum distance:
10-70,000 m (single-mode fiber)
Notes
Power consumption is 0.8 watts typical with 1 watt maximum at 100%
utilization.
For distances less than 20 km, a 10 dB attenuator must be used.
For distances between 20 km and 40 km, a 5 dB attenuator must be used.
Attenuators can be purchased from most cable vendors.
Services
Refer to the HP website at
www.hp.com/networking/services
for details on the
service-level descriptions and product numbers. For details about services and
response times in your area, please contact your local HP sales office.
QuickSpecs
HP 2615 Switch Series
Accessory Product Details
DA - 13673 North America — Version 11 — December 9, 2013
Page 16
Question and Answer IconNeed help?

Do you have a question about the HP 2615 series and is the answer not in the manual?

HP 2615 series Specifications

General IconGeneral
ManageableYes
Power over Ethernet (PoE)No
Jumbo Frame SupportYes
ManagementSNMP
Operating humidity10% to 90% non-condensing

Summary

Overview

Key Features

Highlights core capabilities like scalability, switching, energy efficiency, and form factor.

Connectivity

IEEE 802.3af Power over Ethernet

Details the PoE capabilities per port for powering network devices.

Layer 2 Switching

VLAN Support and Tagging

Explains support for IEEE 802.1Q VLANs and simultaneous VLANs.

Layer 3 Routing

Security

Access Control Lists (ACLs)

Details IP Layer 3 filtering based on source/destination IP and port.

IEEE 802.1X Port Based Network Access Control

Explains 802.1X for port-based network access control.

Secure Protocols for Encryption

Covers SSHv2, SSL, and SFTP for secure management traffic.

Access Control Lists (ACLs)

Details ACLs for network access control and filtering.

Port Security

Allows access only to specified MAC addresses on ports.

Convergence

Monitor and Diagnostics

Flexibility

Product Architecture

Warranty and Support

Lifetime Warranty 2.0

Covers advance hardware replacement and support for the product's lifetime.

Configuration

Cables

Technical Specifications

I/O Ports and Slots

Details the physical ports and interface slots on the switch.

Electrical Characteristics

Lists AC voltage, current, power ratings, and frequency.

Immunity

Standards and Protocols

General Protocols

Lists IEEE standards and RFCs for network protocols like VLANs and routing.

QoS/CoS

Lists RFCs related to Quality of Service and Class of Service.

Accessory Product Details

HP X121 1G SFP LC SX Transceiver (J4858C)

Details specifications for the SX transceiver, including ports, physical, environment, electrical, and cabling.

HP X121 1G SFP LC LX Transceiver (J4859C)

Details specifications for the LX transceiver, including ports, physical, environment, and cabling.

HP X111 100M SFP LC FX Transceiver (J9054C)

Details specifications for the FX transceiver, including ports, physical, environment, cabling, notes, and services.

HP X112 100M SFP LC BX-D Transceiver (J9099B)

Details specifications for the BX-D transceiver, including ports, physical, environment, cabling, and notes.

Accessory Product Details

Related product manuals