Need help?Do you have a question about the HP ProCurve 2610-48-PWR and is the answer not in the manual?
General| Power over Ethernet (PoE) | Yes |
|---|---|
| PoE Power Budget | 370W |
| Jumbo Frame Support | Yes |
| Management | Web-based GUI, CLI, SNMP |
| Rack Mountable | Yes |
| Features | VLAN, QoS |
| Operating Temperature | 0 to 50 °C |
| Operating Humidity | 10% to 90% (non-condensing) |
| Power Supply | 100-240 VAC, 50/60 Hz |
Provides an overview of Power over Ethernet (PoE/PoE+).
Details the capabilities of HP ProCurve PoE switch devices and their support for PoE/PoE+.
Discusses the operating rules and characteristics of HP ProCurve switches and power supplies.
Details how to configure PoE/PoE+ power allocation via the command line interface.
Explains how to use external power supplies for redundant or extra PoE power.
Guides the planning process for building a PoE configuration for 2520/2520G switches.
Shows example configurations and power availability for 8-port 2520/2520G PoE switches.
Guides the planning process for building PoE configurations for 5400zl/8200zl switches.
Details PoE/PoE+ power configurations and redundancy for 5406zl/8206zl switches.
Example configurations using standard J8712A power supplies in 5412zl/8212zl chassis.
Discusses cooling requirements for switches and PoE devices due to heat generation.
Ensures sufficient power supply to the area where switches are mounted, considering dual power supplies.
Example list of planning considerations for any switch series, including device needs and port counts.
Planning phase considerations specific to the 5400zl/8200zl Switches.
To Next Page