HP 2800 - Page 60

58 5 - Control panel ENWW
Novell NetWare frame type parameters
The HP Jetdirect print server automatically selects a NetWare frame type. Select a frame type
manually only when the print server selects an incorrect frame type. To identify the frame type
chosen by the HP Jetdirect print server, print a configuration page from the control panel.
See Understanding and printing the configuration page.
The following frame types are supported:
z Ethernet_802.3
z Ethernet_II
z Ethernet_802.2
z Ethernet_SNAP
Disabling network protocols (optional)
By factory default, all supported network protocols are enabled. Disabling unused protocols
has the following benefits:
z It decreases printer-generated network traffic.
z It prevents unauthorized users from printing to the printer.
z It provides only pertinent information on the Configuration page.
z It allows the control panel to display protocol-specific error and warning messages.
To disable network protocols
Note Do not disable the IPX/SPX protocol if Windows 98, Windows NT, Windows Me,
Windows 2000, or Windows XP users will be printing to the printer.
1 Press (Select button) on the control panel to enter the menus.
2 Press (Down Arrow button) to highlight CONFIGURE DEVICE, and then
press (select button).
3 Press (Down Arrow button) to highlight I/O, and then press (Select button).
4 Press (Down Arrow button) to highlight EIO SUBMENU, and then
press (Select button).
5 Press (Down arrow button) to highlight the network protocol you want to disable,
and then press (Select button).
6 Press (Down Arrow button) to highlight OFF, and then press (Select button).
7 Press (Cancel button) to return to the READY state.