5–40 Maintenance and Service Guide
Removal and Replacement Procedures
4. Turn the docking station right-side up with the front
toward you.
5. Remove the four Phillips PM2.5×5.0 screws 1 that secure
the system board to the base enclosure.
✎
The two screws that secure the front edge of the system board
also secure the EMI spring 4. The front right screw securing the
system board also secures a ground loop 5 on the modem cable.
The EMI spring is available using spare part number 435592-001.
6. Remove the Phillips PM2.5×5.0 screw 2 that secures the
power connector LED lens to the base enclosure.
7. Remove the power connector LED lens 3.
✎
The power connector LED lens is available in the Plastics Kit,
spare part number 435597-001.
Removing the System Board Screws, Part 2
To Next Page
Loading...
