Removal and Replacement Procedures
Maintenance and Service Guide 5–43
11. If it is necessary to replace the monitor stand port cable,
position the system board and shield with the front
toward you.
12. Disconnect the monitor stand port cable 1 from the
system board.
13. Remove the two Phillips PM2.5×5.0 screws 2 that secure
the monitor stand port cable to the system board shield.
14. Remove the monitor stand port cable 3.
✎
The monitor stand port cable is available in the Cable Kit,
spare part number 435586-001.
Removing the Monitor Stand Port Cable
To Next Page
Loading...
