HP 3100

Back view of the HP All-in-One
1 Telephone wall jack
2 Phone cord supplied in the box with your HP All-in-One connected to the "1-
LINE" port
2. After you have connected the phone cord to the port labeled "1-LINE", run
the fax test again to make sure it passes and your HP All-in-One is ready for
faxing.
3. Try to send or receive a test fax.
The "Using Correct Type of Phone Cord with Fax" test failed
Solution
● Make sure you used the phone cord supplied in the box with your HP All-in-
One to connect to the telephone wall jack. One end of the phone cord should
be connected to the port labeled "1-LINE" on the back of your HP All-in-One
and the other end to your telephone wall jack, as shown below.
1 Telephone wall jack
2 Phone cord supplied in the box with your HP All-in-One
Chapter 12
122 HP Photosmart 3100 All-in-One series
Troubleshooting