To Next PageTo Next Page
Need help?Do you have a question about the HP Laser Jet 3390 and is the answer not in the manual?
General| Print Technology | Laser |
|---|---|
| Functions | Print, Copy, Scan, Fax |
| Print Speed | Up to 22 ppm |
| Print Resolution | Up to 1200 x 1200 dpi |
| Maximum Paper Size | 8.5 x 14 in |
| Monthly Duty Cycle | Up to 8, 000 pages |
| Scanner Type | Flatbed, ADF |
| Copy Speed | Up to 22 cpm |
| Copy Resolution | Up to 600 x 600 dpi |
| Fax Modem Speed | 33.6 kbps |
| Fax Memory | Up to 250 pages |
| Processor Frequency | 264 MHz |
| Internal Memory | 64 MB |
| Display | 2-line LCD |
| Duplex Printing | Manual |
| Scan Resolution | Up to 1200 dpi |
| Maximum Number of Copies | Up to 99 copies |
| Fax Transmission Speed | 3 seconds per page |
| Standard Connectivity | Hi-Speed USB 2.0, Ethernet |
| Output Capacity | 125 sheets |
| Operating Systems Supported | Windows, Mac OS |
Procedure to remove the right cover by releasing internal tabs.
Procedure to remove the left cover by releasing tabs and rotating.
Removing the rear cover by unscrewing and releasing hinge mechanisms.
Disconnecting cables and connectors to remove the scanner and ADF assembly.
Loosening screws after opening toner door to prepare for top cover removal.
Disconnecting cable and removing screws to detach the stapler assembly.
Removing the stapler power supply by disconnecting a connector and strap.
Disconnecting connectors and screws to remove the power-switch PCA.
Disconnecting connectors and cables, then removing screws to detach the formatter.
Disconnecting a connector and feeding the wire harness to remove the fan.
Removing screws and carefully lifting the duplex drive assembly from the printer.
Disconnecting a cable and removing a screw to detach the duplex solenoid.
Pressing gear tabs, disconnecting connectors, and releasing wire harness holders.
Pulling wire harness holders and releasing connectors from guides.
Removing screws and spreading chassis to release the fuser from the frame.
Opening the toner cartridge access door to access the transfer roller.
Removing the toner cartridge to gain access to the transfer roller.
Identifying the transfer roller bushing next to the drive gear.
Squeezing tabs on the bushing and lifting to slide and remove the transfer roller.
Removing the tray two pickup roller by detaching the tray and releasing a tab.
Releasing collars and removing screws from the separation pad assembly.
