To Next Page

To Previous Page

When replacing the system board, be sure that the following components are removed from the

defective system board and installed on the replacement system board:

●

SIM (see

SIM on page 34)

●

RTC battery (see

RTC battery on page 43)

●

Memory module (see

Memory module on page 47)

●

Power connector cable (see

Power connector cable on page 63)

●

Fan (see

Fan on page 64)

●

Heat sink (see

Heat sink on page 66)

Remove the system board:

1. Lift the left side of the system board (1) until it rests at an angle.

2. Remove the system board (2) by sliding it up and to the left at an angle.

Reverse this procedure to install the system board.

62 Chapter 4 Removal and replacement procedures

Other manuals for HP 3115m

Questions and Answers:

Need help?

Do you have a question about the HP 3115m and is the answer not in the manual?

General