HP 3314A Manual

Performance Tests
tO
cE.
50 OHM
FEEDTHRU
TERMINATION
Model 3314A
AC/OC
DIGITAL
VOLTMETER
Figure 4-13. Amplitude Accuracy
Procedures:
A. Preset the 3314A.
B. Set the 3314A as follows:
БЕБСДЕЙЕУ оыс ое are heute es 10kHz
AmpBtudé
оао
Arbo
CRY
10Vp-p
C. Set the Digital Voltmeter as follows:
Range ......... s Sea e Deuce e УУ: Auto
Function: y saus ucu asuata OR RE Rec AC
Тт а а ua mar rw oca us Internal
D.
Connect
the
3314A
to
the
Digital
Voltmeter
as
shown
in
Figure
4-13.
NOTE
Cable length between the 3314A and the
Digital Voltmeter should be as short as
possible.
E. Calibrate the 3314A by pressing the Blue Shift Key
followed by the “RCL” Key.
F.
Note
and
record
the
voltage
measured
on
the
Digital
Voltmeter.
Reading
should
be
3.535V
+
0,0477У.
G. Repeat step E.
H. Change the function on the 3314A to a Square
wave.
[. Note and record the voltage measured on the
Digital Voltmeter. Reading should be 5.0V +0.0477V.
4-16
J. Repeat step E.
K. Change the function on the 3314A to a Triangle
wave.
L. Note and record the voltage measured on the
Digital Voltmeter. Reading should be 2.8867V
+0.0477V.
4-14, SINE WAVE POWER FLATNESS
This is a test to check the amplitude flatness of the
3314A Sine wave signal.
Specification:
20Hz to 50kHz
SOkHz to IMHz
1MHz to 19.99MHz
+
0.04dB
~
+
0.1748
>
I
+
0.848
+
у
б)
<
Equipment Required:
AC/DC Digital Voltmeter
3V Thermal Converter
NOTE
For accurate test results, allow the 3314A
and the Thermal Converter time to settle and
adjust to surrounding temperatures. Avoid
sudden temperature changes around the
Thermal Converter.
Procedures:
A. Preset the 33144.

HP 3314A Specifications

General

Brand	HP
Model	3314A
Category	Portable Generator
Language	English