HP 3314A Manual

Model 3314A
General Information
Table 1-1. Specifications (Cont'd)
Symmetry Accuracy (Variable)
+ 0.596 of period:
Frequency: 1Hz to 100kHz
Function: square wave
Phase
Phase Offset--Phase lock Modes
Accuracy: +2° (50Н2 to 25kHz)
Phase Offset is referenced to the signal output for Fin + N or
the trigger input for Fin X N.
Start/Stop Phase--Burst Modes:
Accuracy: «3° (applies from .001Hz to 1kHz)
Function Characteristics
Sine Harmonic Distortion:
individual harmonics will be below these levels, relative to
carrier level.
Offset = OV. Function Invert = OFF.
* Add 4dB for ambient temperature О to 5°C or 45 to 55°С.
20Hz 5OkHz 1999kHz 19.99MHz
Square Wave Rise/Fall Time:
x9ns, 10% to 90% of a 10 Vp-p output
Square Wave Aberrations:
596 of (High Settled Amplitude - Low Settled Amplitude)
where Settled Amplitude is the voltage on the pulse top or
bottom measured 100ns after the appropriate zero crossing.
Frequency: = IMHz
Amplitude: 10Vp-p
10% of р Aberrations relative to programmed amplitude.
Frequency: > 1MHz
Amplitude: 10Vp-p
Triangle Linearity:
+0.2% of the p-p voltage
Frequency: .OTHz to 1kHz, Amplitude = 10 Vp-p
Deviation is from a best fit straight line, from 10% to 90%
of each ramp.
Internal Trigger interval
Period Accuracy: +(0.01% + 50 ppm/year} of displayed in-
terval {excluding sweep intervals)
Frequency Sweep
Sweep Frequency Accuracy--Manual Sweep:
+ (0.2% of Stop Freq + 0.1% of Stop Freq Range}, Stop Freq
Range < 200kHz
+ 196 of Stop Freq, Stop Freq in 2MHz Range
+3% of Stop Freq, Stop Freq in 20MHz Range
Modulation
Amplitude Modulation Envelope Distortion:
x —40dB
Carrier: = 1MHz, 10Vp-p, sine wave
Modulating Input: kHz, sine wave
index of Modulation: 9596
VCO Linearity:
+0.15% of p-p frequency, .1Hz through 200kHz Range
+1% of p-p frequency, 2MHz Range
+3% of p-p frequency, 20MHz Range
-- 8Vdc to + 1 Мас input (— 8096 to + 10%)
Deviation is from a best fit straight line.
Option 001 - Simultaneous X3 Output.
Specifications apply when the X3 Output is terminated with
» 5000 and «500pf and when the Main output is terminated
with 509.
The X3 Output is useable into all loads until the output cur-
rent limits at = 30 mA peak or the output voltage clips at
= 15V peak.
X3 Gain Accuracy:
* 1% at 10КН2
ХЗ Output amplitude = (3 + 1%)x Main Output Amplitude
Sine Power Flatness:
Relative to full output power at 10kHz
20Hz 50kHz 500KHz 1MHz
Harmonic Distortion:
АН harmonically related signals will be below these levels.
relative to the fundamental.
20Hz 50kHz 1MHz
~ 53dB ~ 38dB
Square Wave Rise/Fall Time: (Rear Panel)
« 200ns, 10% to 90% at full output.
Residual DC Offset: (Rear Panel)
= 40mVDC

HP 3314A Specifications

General

Brand	HP
Model	3314A
Category	Portable Generator
Language	English