HP 3500 Series - Page 342

328 Troubleshooting ENWW
40 BAD SERIAL
TRANSMISSION
alternates with
To continue press
HP 3700 only.
A serial data error (parity, framing, or
line overrun) has occurred while the
printer
was receiving data.
Press to continue printing.
Note: A loss of data will occur.
40 EIO X BAD
TRANSMISSION
alternates with
To continue press
HP 3700 only when an EIO device is
installed.
A connection with the card in the EIO
slot has been abnormally broken.
Press to continue printing.
Note: A loss of data will occur.
41.3 UNEXPECTED
SIZE IN TRAY X
alternates with
LOAD TRAY X
<TYPE> <SIZE>
Paper is loaded that is longer or
shorter in the feed direction than the
size configured for the tray.
1. Load the paper as instructed.
2. Press to print.
3. If the incorrect size was selected, press
Stop to cancel the job or press for help.
4. If the incorrect tray was selected, press
Stop to cancel the job.
5. Configure the trays correctly and resend
the job.
Ensure all trays are configured correctly.
41.5 UNEXPECTED
TYPE IN TRAY X
alternates with
LOAD TRAY X
<TYPE> <SIZE>
The printer senses a different paper
type in the paper path than what is
configured in the tray.
1. Load the paper as instructed.
2. Press to print.
3. If the incorrect type was selected, press
Stop to cancel the job or press for help.
4. Configure the trays correctly and resend
the job.
Ensure all trays are configured correctly.
Table 7-3 Numerical printer messages (continued)
Message
Description Action