HP 3500 Series

402 Troubleshooting ENWW
OPTIMIZE T1 UP
T1 DOWN
T2 UP 1
T2 UP 2
T2 DOWN 1
T2 DOWN 2
LEADING EDGE UP
LEADING EDGE DOWN
REDUCE BKGROUND 1
REDUCE BKGROUND 2
FUSER DOWN 1
FUSER DOWN 2
FILM OFFSET
GHOST PREVENTION
PRE-ROTATION
RESTORE OPTIMIZE
Allows you to optimize certain parameters
for all jobs rather than (or in addition to)
optimizing by paper type. The default for
each item is OFF. RESTORE OPTIMIZE
resets all of the values to OFF.
T1 UP - Use when toner does not
adequately transfer from the print cartridge
drum to the ITB.
T1 DOWN - Use when toner transfers
unevenly from the print cartridge drum to
the ITB.
T2 UP 1 - Use when poor transfer occurs
on the entire surface of the media from the
ITB to the paper at the secondary transfer
roller.
T2 UP 2 - Use when T2 UP 1 did not
completely solve the problem.
T2 DOWN 1 - Use when poor transfer in
black or freckles appear on the entire
surface of the media, especially in purple.
T2 DOWN 2 - Use when T2 DOWN 1 did
not completely solve the problem.
LEADING EDGE UP - Unassigned.
LEADING EDGE DOWN - Unassigned.
REDUCE BKGROUND 1 - Unassigned.
REDUCE BKGROUND 2 - Unassigned.
FUSER DOWN 1 - Use when hot offset
occurs (the image repeats because toner
sticks to the fuser film instead of the paper;
toner gets transferred to the paper later, in
the wrong place).
FUSER DOWN 2 - Use when FUSER
DOWN 1 did not completely solve the
problem.
FILM OFFSET - Use when fuser
electrostatic offset occurs (like fuser hot
offset but is caused by an electrostatic
charge on the fuser film).
GHOST PREVENTION - Use when
positive ghost appears.
Table 7-44 Print quality menu (continued)
Menu item Values Description