404 Troubleshooting ENWW
System setup menu
The system setup menu allows you to make changes to default settings for general printer
configuration, such as PowerSave Time, printer personality (language), and jam recovery.
Table 7-45 System setup submenu
Menu item Values Description
SHOW ADDRESS AUTO
OFF
AUTO allows the printer's IP address to be
shown on the printer control panel,
alternating with the Ready message. The
default is OFF.
This menu item is displayed only if the printer
is connected to a network (available for the
HP Color LaserJet 3700n, 3700dn, and
3700dtn printer models).
COLOR/BLACK MIX AUTO
MOSTLY COLOR PAGES
MOSTLY BLACK PAGES
This menu item establishes how the printer
switches from color to monochrome (black
and white) mode for maximum performance
and print cartridge life.
AUTO will reset the printer to the factory
default setting. The default is AUTO.
Select MOSTLY COLOR PAGES if nearly all
of your print jobs are color with high page
coverage.
Select MOSTLY BLACK PAGES if you print
mostly monochrome print jobs, or a
combination of color and monochrome print
jobs.
TRAY BEHAVIOR USE REQUESTED TRAY
MANUALLY FEED PROMPT
PS DEFER MEDIA
Allows you to specify settings for the tray
selection behavior. (This setting allows you
to configure the trays to behave like trays in
some previous HP printers.)
The default for USE REQUESTED TRAY is
EXCLUSIVELY.
The default for MANUALLY FEED PROMPT
is ALWAYS.
PS DEFER MEDIA affects how paper is
handled when printing from an Adobe PS
print driver. ENABLED uses HP's paper
handling. Disabled uses the Adobe PS
paper handling. The default is ENABLED.
POWERSAVE TIME 2 MINUTE
15 MINUTES
30 MINUTES
1 HOUR
4 HOURS
15 HOURS
Reduces power consumption when the
printer has been inactive for an extended
period.
Allows you to set the length of time the
printer remains inactive before going into
PowerSave mode. The default is
30 MINUTES.
To Next Page
Loading...
