HP 3500 Series - Page 75

ENWW Using PowerSave Time 61
Using PowerSave Time
The adjustable PowerSave Time feature reduces power consumption when the printer has been
inactive for an extended period. You can set the length of time before the printer goes into
PowerSave mode to 1 MINUTE, 15 MINUTES, 30 MINUTES, or to 1 HOUR, 1.5 HOURS, 2
HOURS, or 4 HOURS. The default setting is 30 MINUTES.
Note The printer display appears dimmed when the printer is in PowerSave mode. PowerSave mode does
not affect printer warm-up time, unless the printer is in PowerSave mode for more than eight hours.
To set PowerSave Time
1 Press MENU to enter the MENUS.
2 Press to highlight CONFIGURE DEVICE.
3 Press to select CONFIGURE DEVICE.
4 Press to highlight SYSTEM SETUP.
5 Press to select SYSTEM SETUP.
6 Press to highlight POWERSAVE TIME.
7 Press to select POWERSAVE TIME.
8 Press or to select the appropriate time period.
9 Press to set the time period.
10 Press M
ENU.
To disable/enable PowerSave
1 Press MENU to enter the MENUS.
2 Press to highlight CONFIGURE DEVICE.
3 Press to select CONFIGURE DEVICE.
4 Press to highlight RESETS.
5 Press to select RESETS.
6 Press to highlight POWERSAVE.
7 Press to select POWERSAVE.
8 Press or to select ON or OFF.
9 Press to set the selection.
10 Press M
ENU.