ENWW Installing memory and font DIMMs 79
Enabling the language font DIMM (hp color LaserJet 3700 only)
If you installed a language font DIMM in the printer, you must select the Font DIMM option in the
printer driver for the font DIMM to work properly.
To enable fonts from the PCL 6 printer driver for Windows
1 On the Start menu, point to Settings, and click Printers.
2 Select this printer and select Properties.
3 On the Configure tab, click More.
4 Select the Font DIMM check box.
5 In the Configure Font DIMMs dialog box, click Add to add the font file.
6 In the Add Font DIMM dialog box, browse to the location of the font file, select the font file,
and click OK.
7 In the Configure Font DIMMs dialog box, select the installed DIMM.
8 Click OK.
9 Print a configuration page.
Checking DIMM installation (hp color LaserJet 3700 only)
Check that the DIMMs are installed correctly and working.
To check DIMM installation
1 Turn the printer on. Check that the Ready light is on after the printer has gone through the
startup sequence. If an error message appears, a DIMM may have been incorrectly installed.
2 Print a configuration page.
3 Check the Installed Personalities and Options section on the configuration page and compare
it with the configuration page printed before the DIMM installation.
4 If the amount of recognized memory has not increased:
The DIMM may not be installed correctly. Repeat the installation procedure.
The DIMM may be defective. Try a new DIMM.
To Next Page
Loading...
