EasyManuals Logo
Home>HP>Switch>3600 v2 Series

HP 3600 v2 Series Compliance And Safety Manual

HP 3600 v2 Series
51 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #26 background imageLoading...
Page #26 background image
22
Набор кабелей должен быть одобрен UL и иметь сертификат CSA
Минимальные требования для гибких кабелей
18 AWG
Тип SV/SVT, SJ/SJT или SPT-2
Трехжильный
Номинальный допустимый ток набора кабелей должен быть не менее
10 А.
Вилка должна иметь заземление с типом конфигурации NEMA 5-15P
(15 А, 125 В) или NEMA 6-15P (15 А, 250В)
Дріт має бути затверджений в UL і сертифікований у CSA.
Мінімальні вимоги до гнучкого дроту:
AWG: 18 ;
тип: SV/SVT, SJ/SJT або SPT-2;
кількість провідників: 3;
номінально допустимий струм: від 10 A.
Рознім: штекер із заземленням і конфігурацією NEMA 5-15P (15А, 125
В) або NEMA 6-15P (15 А, 250 В).
United Kingdom
英国
󵪨󴈔
Royaume-Uni
Regno Unito
Reino Unido
Reino Unido
Біріккен
Корольдік
Великобритания
Великобританія
The supply plug must comply with BS1363 (3-pin, 13A) and be fitted with
a 13A fuse that complies with BS1362
The mains cord must <HAR> or <BASEC> marked and be of type
H03VVF3G1.0 (minimum).
電源プラグは、BS1363 (3 ピン、13A) に準拠し、BS1362 に準拠した 13A
のヒューズを装着したものである必要があります。
電源コードは <HAR> または <BASEC> のマークが
H03VVF3G1.0
(最小) である必要があります。
󵲫󵭷󶦳󴲓󴊟󴂧 󶧧󵩷󵲨󶨐󶨃󴊃󴅐󵰛󴆇
󴊃󴅐󵯫󴧗󴸛󴜻󶦏󵸯󵫧󶨏󴍿󵕓󵭐󴢿󵩛󵨣󶨐󴝯󴞋
󵶣󶏻󴦃󴂧󶪼󵞄󶈃󵘳󵰛󴆇󴪷󴜻
󶤃󵞃󴂧󵰯󵩛󵨣󶨐󴝯󴞋
La prise d'alimentation doit être de type BS1363 (3 broches, 13 A) et
équipée d'un fusible de 13A conforme à la norme BS1362.
Le câble secteur doit porter la mention <HAR> ou <BASEC> et être de
type H03VVF3G1.0 (minimum).
La spina di alimentazione di corrente deve essere conforme allo standard
BS1363 (3 poli, 13 A) ed essere dotata di un fusibile a 13 A conforme a
BS1362.
Il cavo di alimentazione deve essere contrassegnato con <HAR> o
<BASEC> ed essere di tipo H03VVF3G1.0 (minimo).
El enchufe de la fuente debe cumplir con BS1363 (3 clavijas, 13A) y
contar con un fusible de 13A que cumpla con BS1362.
El cable de la alimentación debe tener la marca <HAR> o <BASEC> y
ser del tipo H03VVF3G1.0 (mínimo).
O plugue da fonte deve estar em conformidade com BS1363 (3 pinos, 13
A) e ser equipado com um fusível de 13 A que esteja em conformidade
com BS1362.
O cabo de alimentação deve ter a marca <HAR> ou <BASEC> e ser do
tipo H03VVF3G1.0 (mínimo).

Table of Contents

Other manuals for HP 3600 v2 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP 3600 v2 Series and is the answer not in the manual?

HP 3600 v2 Series Specifications

General IconGeneral
BrandHP
Model3600 v2 Series
CategorySwitch
LanguageEnglish

Related product manuals