EasyManua.ls Logo

HP A3100 v2 Series User Manual

HP A3100 v2 Series
56 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
HP A3100 v2 Switch Series
Compliance and Safety Manual
59981960
H3C S3100V2 Switch Series
Hangzhou H3C Technologies Co., Ltd.
BOM: 3122A0AE
Part number: 5998-1960
Document version: 5PW100-20110430
Question and Answer IconNeed help?

Do you have a question about the HP A3100 v2 Series and is the answer not in the manual?

HP A3100 v2 Series Specifications

General IconGeneral
Product SeriesA3100 v2 Series
Port Type10/100/1000BASE-T
DimensionsVaries by model
WeightVaries by model
Power over Ethernet (PoE)Available on select models
Jumbo Frame SupportYes
VLAN SupportYes
Layer 3 FeaturesStatic routing, RIP
Quality of Service (QoS)Yes
Security FeaturesIEEE 802.1X, ACLs, Port Security
ManagementWeb, CLI, SNMP
Operating Temperature0°C to 45°C
Operating Humidity10% to 90% non-condensing
Power SupplyInternal
WarrantyLifetime
Ports8 to 48 ports

Summary

Legal and Notice Information

Safety Information

General Warnings

Installation and removal must be done by qualified personnel. Read safety instructions.

Important Safety Notes

Read operation instructions and precautions carefully to minimize accidents.

Conventions Used

Important Safety Information

Qualified Personnel for Installation

Installation and removal must be carried out by qualified personnel.

Ventilation and Clearance

Do not block ventilation openings and maintain 5 cm distance.

Grounding Procedure

Always make the ground connection first and disconnect it last.

Mains Supply System

Device is suitable for TN power systems; not for IT systems without transformer.

DC Power Supply Safety

For DC supplied models, reinforced insulation is required between DC and AC mains.

AC Power Disconnection

Plug-socket combination must be accessible; turn off switch before cable work.

Power Cable and Mounting

Confirm cable compliance and use appropriate screws/caps for wall mounting.

Permanent Ground Connection Requirement

Unit must be permanently connected to protective ground before operation.

Power Cord Set

Cord Set Approval and Specifications

Power cord set must be UL approved and CSA certified with specific ratings.

Redundant Power Systems (RPS)

Electricity Safety

AC Power Supply Installation

Follow local safety regulations and use qualified personnel for AC operations.

Conductive Articles Removal

Remove conductive items like watches, rings during installation.

High Voltage Operations Safety

Non-standard high voltage operations can cause fire/shock. Follow local rules.

High Voltage Personnel Qualification

Personnel for high voltage operations must be qualified.

Fiber Optic Ports Safety

Laser Emission Control

Using controls not specified may cause hazardous laser emissions.

Regulatory Compliance Information

EMC Compliance Standards

Lists standards for EMC compliance (FCC, ICES, VCCI, CISPR, EN, etc.).

Safety Standards

Lists safety standards (UL, CAN/CSA, IEC, EN, FDA, GB).

European Directives Compliance

Products comply with Low Voltage Directive and EMC Directive.

WEEE Directive Compliance

Products must be disposed of responsibly according to WEEE Directive.

USA and Canada Compliance

FCC, FDA, and ICES-003 requirements for Class A devices.

Japan Compliance

Compliance with VCCI Class A for Information Technology Equipment.

EN55022, AS/NZS CISPR 22 CISPR22 Compliance

Compliance with CISPR 22 for Class A Information Technology Equipment.

CCC Class A Statement

Product may cause radio interference in domestic environments; user may need corrective actions.

Regulatory Compliance Notices

Recycling Notices

Do not dispose of product with household waste; use designated collection points.

Related product manuals